Informacja

Drogi użytkowniku, aplikacja do prawidłowego działania wymaga obsługi JavaScript. Proszę włącz obsługę JavaScript w Twojej przeglądarce.

Wyszukujesz frazę "active inverter" wg kryterium: Temat


Wyświetlanie 1-7 z 7
Tytuł:
GaN-based soft-switched active power buffer operating at ZCS – problems of start-up and shut-down
Autorzy:
Rąbkowski, J.
Król, K.
Zdanowski, M.
Sochacki, M.
Powiązania:
https://bibliotekanauki.pl/articles/201868.pdf
Data publikacji:
2020
Wydawca:
Polska Akademia Nauk. Czytelnia Czasopism PAN
Tematy:
GaN
power inverter
active buffer
Opis:
This paper describes practical issues related to control of the active power buffer (APB) developed for a 2 kVA single-phase inverter. The buffer is designed using the latest GaN HEMTs controlled with triangular current mode to reduce switching losses, however, the switching frequency should be limited to 1 MHz. In the case of the presented analogue-digital controller, frequency is influenced by a reference current of the APB and circuit. Therefore, the operation at start-up and shut-down is especially challenging. A modified control algorithm that also includes pre-charging and discharging process of the energy buffer is presented and experimentally verified by series of tests of the 2 kVA GaN based inverter with the APB.
Źródło:
Bulletin of the Polish Academy of Sciences. Technical Sciences; 2020, 68, 4; 785-792
0239-7528
Pojawia się w:
Bulletin of the Polish Academy of Sciences. Technical Sciences
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Mechatronic system with the control of voltage in permanent magnet synchronous generator
Autorzy:
Tarnapowicz, D.
German-Galkin, S.
Powiązania:
https://bibliotekanauki.pl/articles/27315954.pdf
Data publikacji:
2018
Wydawca:
STE GROUP
Tematy:
PMSG
voltage regulation of PMSG
active inverter
regulacja napięcia PMSG
falownik aktywny
Opis:
In recent years, the use of Permanent Magnet Synchronous Generator (PMSG) in ship power plant system has increased. PMSGs are characterized by better properties than the classic and commonly used synchronous generators. In comparison with classic synchronous generators, PMSGs do not have a voltage regulator, and hence as the load increases, the voltage at the output of the generator decreases. The article presents the use of an active voltage inverter with the task to maintain a constant voltage on the receiver along with the load’s increase. Simulation studies confirming the effectiveness of the proposed method were carried out
Źródło:
New Trends in Production Engineering; 2018, 1, 1; 531-537
2545-2843
Pojawia się w:
New Trends in Production Engineering
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
The DC-side active filter with dual-buck full-bridge inverter for wind generators
Autorzy:
Chen, X-Q.
Zhao, S-W.
Wang, Y.
Powiązania:
https://bibliotekanauki.pl/articles/141358.pdf
Data publikacji:
2018
Wydawca:
Polska Akademia Nauk. Czytelnia Czasopism PAN
Tematy:
multi-pulse ac-dc converter
auto-transformer
harmonic suppression
DC-side active filter
dual-buck full-bridge inverter
Opis:
This paper proposes a new dc-side active filter for wind generators that combines 12-pulse polygon auto-transformer rectifier with dc-side current injection method and dual-buck full-bridge inverter having not the “shoot-through” problem in conventional bridge-type inverters, and therefore this system with the character low harmonic distortion and high reliability. The proposed dc-side active filter is realized by using dual-buck full bridge converter, which directly injects compensation current at dc-side of two six-pulse diode bridges rectifiers. Compared with the conventional three-phase active power filter at ac-side, the system with the dc-side active filter draws nearly sinusoidal current by shaping the diode bridges output current to be triangular without using the instantaneous reactive power compensation technology, only using simple hysteretic current control, even though under load variation and unbalanced voltage disturbances, and while an acceptable linear approximation to the accurate waveform of injection current is recommended. The performance of the system was simulated using MATLAB/Simulink, and the possibility of the dc-side active filter eliminating current harmonics was confirmed in steady and transient states. The simulation results indicate, the system has a total harmonic distortion of current reduced closely to 1%, and a high power factor on the wind generator side.
Źródło:
Archives of Electrical Engineering; 2018, 67, 2; 263--277
1427-4221
2300-2506
Pojawia się w:
Archives of Electrical Engineering
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Sterowanie wielopoziomowym filtrem aktywnym z selektywną kompensacją harmonicznych
Control of multilevel active power filter with selective harmonic compensation
Autorzy:
Banach, P.
Cichowski, A.
Powiązania:
https://bibliotekanauki.pl/articles/268282.pdf
Data publikacji:
2015
Wydawca:
Politechnika Gdańska. Wydział Elektrotechniki i Automatyki
Tematy:
filtr aktywny
selektywna kompensacja harmonicznych
falownik wielopoziomowy NPC
active power filter
selective compensation
multilevel inverter NPC
Opis:
W artykule przedstawiono metodę sterowania wielopoziomowym równoległym filtrem aktywnym z możliwością selektywnej kompensacji wybranych harmonicznych prądu z uwzględnieniem ograniczeń prądowych przekształtnika. Falownik wielopoziomowy umożliwia dokładniejsze generowanie napięcia wyjściowego przy mniejszej częstotliwości modulacji oraz umożliwia zmniejszenie wymiarów filtrów sieciowych względem klasycznego falownika dwupoziomowego. Użycie algorytmu selektywnej kompensacji pozwala na zastosowanie przekształtnika o mniejszej mocy i skompensowanie tylko wybranych wyższych harmonicznych. Przedstawiono wyniki symulacji wykonanej w programie Matlab proponowanej metody sterowania, którą oparto na algorytmie adaptacyjnym na przykładzie wybranej harmonicznej.
In this paper a control method of multilevel active power filter (APF) with selective harmonic compensation (SHC) is presented. The parallel APF is one of the most popular topology of the power quality improvement devices and is connected between power coupling point and nonlinear load to compensate current harmonics. Nowadays multilevel converters become increasingly popular because of its advantages such as: low output voltage THD, lower current ripple, low grid filters size and weight, possibility of using lower voltage of semiconductors. There are a lot of papers concerning SHC, but most of them do not consider maximum current limit of the inverter. The APF uses Phase Locked Loop to synchronise with the grid and to eliminate harmonics in the grid voltage a Cascaded Delayed Signal Cancellation is implemented. The reference current is estimated by adaptive filter using least means squares learning method with estimated value limitation. In order to generate compensation current a predictive controller is implemented. Output voltages generation and stabilization of neutral point voltage of the multilevel inverter is based on a shape-function space vector modulator. The simulation in Matlab is prepared.
Źródło:
Zeszyty Naukowe Wydziału Elektrotechniki i Automatyki Politechniki Gdańskiej; 2015, 47; 19-22
1425-5766
2353-1290
Pojawia się w:
Zeszyty Naukowe Wydziału Elektrotechniki i Automatyki Politechniki Gdańskiej
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Use of asymmetrical currents waveforms to detect and localize open switch faults for two level voltage source inverter three-phase shunt active power filter
Autorzy:
Benslimane, T.
Chetate, B.
Abdelkrim, T.
Powiązania:
https://bibliotekanauki.pl/articles/229453.pdf
Data publikacji:
2011
Wydawca:
Polska Akademia Nauk. Czytelnia Czasopism PAN
Tematy:
active power filter
fault detection
two level there phase voltage source inverter
current mean value
Opis:
This paper proposes an open switch faults detection and localization algorithm for shunt three phase active filter topology. It mainly details converter configuration and examines a simple and reliable optimized fault diagnosis method. The converter topology is based on classical three-leg active power filter topology. New fault diagnosis method is proposed, based on classical currents measurements. It includes combinatory logic to analyze and validate error signals. Hysteresis control is applied before and after fault detection, which avoids any controller reconfiguration. Simulation results obtained with Matlab/Simulink/Plecs tools prove the effectiveness of this method.
Źródło:
Archives of Control Sciences; 2011, 21, 1; 105-117
1230-2384
Pojawia się w:
Archives of Control Sciences
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Feedback control of three-Level PWM rectifier: Application to the stabilization of DC Voltages of five-level NPC active power filter
Autorzy:
Abdelkrim, T.
Berkouk, E. M.
Benslimane, T.
Benamrane, K.
Powiązania:
https://bibliotekanauki.pl/articles/229851.pdf
Data publikacji:
2010
Wydawca:
Polska Akademia Nauk. Czytelnia Czasopism PAN
Tematy:
active power filter
NPC multilevel inverter
feedback control
PWM current rectifier
clamping bridge filter
Opis:
One of the most important drawbacks of the three phases five-level NPC (Neutral Point Clamped) Active Power Filter (APF) is the neutral point balance. As the consequence, the capacitors voltages of the input DC bus of the APF are not equal which constitutes the major limitation for the use of this power converter. In order to stabilize these DC voltages, it is proposed in this paper to study the cascade constituted by three phases three-level PWM rectifier-clamping bridge filter-five-level NPC APF. In the first part, the authors present a topology of five-level NPC Voltage Source Inverter (VSI), and then, they propose a model of this converter and its PWM control strategy. In the second part, the modeling and control of three-level PWM current rectifier is presented. In the third part, to remedy to instability problem of the input capacitors DC voltages of the APF, the authors propose feedback control of the three-level PWM rectifier followed by clamping bridge filter. After that, the sliding mode regulator used to control the active filter is developed. The obtained results are full of promise to use this topology of APF in high voltage and high power applications.
Źródło:
Archives of Control Sciences; 2010, 20, 3; 317-339
1230-2384
Pojawia się w:
Archives of Control Sciences
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
A new active method of protection against electrical shock in low voltage ship networks: experimental results
Nowa aktywna metoda ochrony przeciwporażeniowej w sieciach okrętowych niskiego napięcia: badania eksperymentalne
Autorzy:
Tarnapowicz, D.
Powiązania:
https://bibliotekanauki.pl/articles/256131.pdf
Data publikacji:
2008
Wydawca:
Sieć Badawcza Łukasiewicz - Instytut Technologii Eksploatacji - Państwowy Instytut Badawczy
Tematy:
ochrona przeciwporażeniowa
kompensacja parametryczna
kompensacja aktywna
falownik czteroprzewodowy
protection against shock current
parametric compensation
active compensation
four-leg inverter
Opis:
The commonly applied electrical networks with an insulated neutral point in ships are not able to protect against electric shock, due to the presence of capacitance between phase wires and the hull, which increases the values of shock current. A new approach to solve this problem is presented. The new idea is based on active compensation of shock current using current sources inserted between the phase wires and the metallic hull. A four-leg transistor inverter controlled by a signal processor (DSP) and a logic programmable array (FPGA) was used as a set of current sources. The arrangement of the test stand obtained for the experimental checking of the concept compensation of shock current is presented together with the experimental results.
Powszechnie stosowane w okrętownictwie sieci elektryczne z izolowanym punktem zerowym z powodu występowania pojemności doziemnych (powodujących wzrost prądu rażenia) nie zapewniają ochrony przeciwporażeniowej. Autor prezentuje nowe podejście do rozwiązania tego problemu. Nowa idea aktywnej kompensacji prądu rażenia człowieka polega na włączaniu pomiędzy przewody fazowe a kadłub statku aktywnych źródeł prądu. W proponowanym rozwiązaniu jako źródła prądowe został wykorzystany falownik w układzie czteroprzewodowym. W referacie przedstawiono układ stanowiska badawczego, przeznaczonego do eksperymentalnego sprawdzenia koncepcji aktywnej kompensacji prądu rażenia w sieciach okrętowych niskiego napięcia, oraz wyniki badań.
Źródło:
Problemy Eksploatacji; 2008, 1; 137-145
1232-9312
Pojawia się w:
Problemy Eksploatacji
Dostawca treści:
Biblioteka Nauki
Artykuł
    Wyświetlanie 1-7 z 7

    Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies