Informacja

Drogi użytkowniku, aplikacja do prawidłowego działania wymaga obsługi JavaScript. Proszę włącz obsługę JavaScript w Twojej przeglądarce.

Wyszukujesz frazę "wet synthesis" wg kryterium: Temat


Wyświetlanie 1-2 z 2
Tytuł:
Studies on sintering process of synthetic hydroxyapatite
Autorzy:
Malina, Dagmara
Biernat, Kamila
Sobczak-Kupiec, Agnieszka
Powiązania:
https://bibliotekanauki.pl/articles/1039506.pdf
Data publikacji:
2013
Wydawca:
Polskie Towarzystwo Biochemiczne
Tematy:
calcium phosphates
hydroxyapatite
sintering process
wet synthesis
Opis:
In this study the effect of sintering process in different temperatures on microstructure and morphological properties of sintered hydroxyapatite (HAp) was investigated. HAp powder was prepared by wet precipitation method from following reagents: Ca(OH)2 + H3PO4 in an alkaline conditions. Thermal analysis (TA), X-Ray diffraction method (XRD), FT-IR spectrometry (FT-IR) and scanning electron microscopy (SEM) were used to elaborate the phase composition and properties of sintered HAp samples and raw HAp powder as well. The total and apparent density and total porosity of sintered compacts, shrinkage and weight loss during the sintering were also measured. The results show that there is a difference in sintering behavior of synthetic hydroxyapatites depending on sintering temperature. The main differences refer to the loss of mass, shrinkage, changes in porosity and density of the investigated materials.
Źródło:
Acta Biochimica Polonica; 2013, 60, 4; 851-855
0001-527X
Pojawia się w:
Acta Biochimica Polonica
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Effects Of Process Parameters On Cu Powder Synthesis Yield And Particle Size In A Wet-Chemical Process
Wpływ parametrów procesu na wydajność syntezy proszku Cu i wielkości cząstek w procesie mokrym chemicznym
Autorzy:
Shin, Y. M.
Lee, J. H.
Powiązania:
https://bibliotekanauki.pl/articles/354168.pdf
Data publikacji:
2015
Wydawca:
Polska Akademia Nauk. Czytelnia Czasopism PAN
Tematy:
wet-chemical process
micron-size Cu powder
Synthesis yield
particle size
gibbs free energy difference
proszek Cu
proces chemiczny mokry
wydajność syntezy
rozmiar cząsteczki
różnica energii swobodnej Gibbsa
Opis:
This study presents a simple wet-chemical process to prepare several micron-size Cu powders. Moreover, changes in powder synthesis yield and particle size are examined with different solvents, synthesis temperatures, and amounts of reducing agent during the synthesis. As a reducing agent and capping agent, L-ascorbic acid and polyvinyl pyrrolidone were used, respectively. The yields in distilled water or an ethylene glycol (EG)/distilled water mixture were higher than that in EG alone, and the yield increased with increasing temperature owing to a lower Δ Gred value. Increasing the L-ascorbic acid concentration also increased the yield. The Cu powder synthesized in 3 h at 90°C in distilled water with 272.8 mM of L-ascorbic acid showed the lowest average particle size of 2.52 μm, indicating mechanisms of short burst nucleation and reduced growth via the increased reduction rate of Cu ions. It is estimated that the nucleation step was nearly completed within 10 min in this system. The Cu powders synthesized in an ethylene glycol/distilled water mixture presented an average particle size of 3.76 μm and the highest yield of 87.9%.
Źródło:
Archives of Metallurgy and Materials; 2015, 60, 2B; 1247-1250
1733-3490
Pojawia się w:
Archives of Metallurgy and Materials
Dostawca treści:
Biblioteka Nauki
Artykuł
    Wyświetlanie 1-2 z 2

    Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies