- Tytuł:
- Operating parameters of slide micro – bearings with consideration of oil temperature changes and micro - grooves on sleeve surface
- Autorzy:
- Miszczak, A.
- Powiązania:
- https://bibliotekanauki.pl/articles/247490.pdf
- Data publikacji:
- 2012
- Wydawca:
- Instytut Techniczny Wojsk Lotniczych
- Tematy:
-
HDD micro-bearings
micro-grooved surfaces
oil viscosity changes in gap height
hydrodynamic pressure
friction forces
load carrying capacity - Opis:
- In this paper author presents results of numerical calculations of hydrodynamic pressure distribution in bearing gap, load-carrying capacity, friction force and friction coefficient of slide micro-bearing considering the influence of lubricating oil temperature changes and also taking into account the influence of micro-grooves, which occur on sleeve internal surface. The micro-grooves on that surface are in longitudinal direction. The equation, which describes a bearing gap with micro-grooves on sleeve surface, was adopted from prof. K Wierzcholski's investigations. In very thin gap height of cylindrical micro-bearings, large gradients of temperature can be observed. This causes significant changes of oil dynamic viscosity in the gap height direction. According to this, oil flow velocity, friction forces, and a hydrodynamic pressure during the micro-bearing operation are changing. Up to now the influence of temperature on oil viscosity changes and due to this, on hydrodynamic pressure and on load carrying capacity in cylindrical micro-bearing gap in numerical way were not considered yet. The numerical calculations were performed with the use of Mathcad 14. The finite differences method and own computational procedures were implemented. The calculations were begun by solving the Reynolds' equation, assuming, that the dynamic viscosity is constant. After calculating the hydrodynamic pressure distribution, the temperature distribution in lubricating oil was determined. The obtained function of temperature was used to describe the viscosity changes with temperature. Next step involved determining the hydrodynamic pressure distribution taking into account the viscosity dependence on temperature, and then new distribution of temperature and again new values of viscosity were calculated. Calculations were repeated until assumed convergence and accuracy were reached. The friction force depends on pressure gradient and rotational motion of bearing journal. Part of friction force, which resulting from the pressure gradient, is determined for the area, where the oil film occurs, i.e. from omega p to omega k. Part of friction force, which is related to journal motion, is determined for full wrap angle, i.e. from 0 to 2 pi. The results were presented in the form of graphs, for eccentricity ratio gamma from 0.1 to 0.9, for dimensionless length of the bearing L1=1/4. In numerical calculations were used the theoretical considerations and solutions presented in papers of K. Wierzcholski and A. Miszczak.
- Źródło:
-
Journal of KONES; 2012, 19, 2; 329-336
1231-4005
2354-0133 - Pojawia się w:
- Journal of KONES
- Dostawca treści:
- Biblioteka Nauki
Artykuł