- Tytuł:
- Analysis of the Impact of Wiper Geometry Insert on Surface Roughness and Chips in Machining Materials Used in the Aviation Industry
- Autorzy:
-
Szablewski, Piotr
Smak, Krzysztof
Krawczyk, Bartłomiej - Powiązania:
- https://bibliotekanauki.pl/articles/2022247.pdf
- Data publikacji:
- 2022
- Wydawca:
- Stowarzyszenie Inżynierów i Techników Mechaników Polskich
- Tematy:
-
surface roughness
chips
turning
Wiper
aviation materials - Opis:
- Nowadays, great emphasis is placed on increasing the efficiency of machining processes. However, this cannot be done at the expense of quality worsening of the machined surface. In this paper the influence of Wiper geometry on Ra and Rz surface roughness parameters is described when finishing turning of materials used in the aviation industry: austenitic stainless steel XCrNiNb18-9, low alloy steel 14NiCr14 and aluminum alloy A356, as well as the chips generated in the cutting process in terms of shape were assessed. It was found that for the lowest tested feed rate during turning with a Wiper insert, the values of Ra and Rz parameters do not differ significantly from the roughness parameters obtained during machining with a conventional insert. The beneficial effect of feed rate on surface roughness for the Wiper insert is clearly visible above f ≥ 0.12 mm/rev. The biggest difference in roughness parameters was recorded for the highest value of the applied feed f = 0.28 mm/rev. Using conventional insert, Ra and Rz values are almost three times bigger than for Wiper insert. The influence of the cutting speed on the Ra and Rz parameters depends on the type of material being processed. Increasing cutting speed from vc =120 m/min to vc = 200 m/min for stainless steel, Ra and Rz values decrease about 35%. Similar situation noticed for aluminum alloy, but increasing cutting speed decrease Ra and Rz values only about 18%. The situation is different for low alloy steel. Increasing the cutting speed increases the Ra and Rz parameters by about 37%. Rz/Ra ratio shows that for feed rate f ≤ 0.12 mm/rev. cutting process is unstable, because the values are between 5.5–7.5, but should oscillate around 4. Increasing feed rate value to f = 0.2 mm/rev allows to stabilize the process and the ratio value is close to 4. Wiper insert create the same form chips as a conventional insert, using the same value of feed rate.
- Źródło:
-
Advances in Science and Technology. Research Journal; 2022, 16, 1; 203-212
2299-8624 - Pojawia się w:
- Advances in Science and Technology. Research Journal
- Dostawca treści:
- Biblioteka Nauki
Artykuł