- Tytuł:
-
A Study Of The Die Roll Height Of SHP-1 And SCP-1 Materials In The Fine Blanking Process
Badanie wysokości deformacji krawędzi wycinanych elementów ze stali SHP-1 i SCP-1 procesie wykrawania - Autorzy:
-
Lee, C. K.
Kim, Y. C. - Powiązania:
- https://bibliotekanauki.pl/articles/356499.pdf
- Data publikacji:
- 2015
- Wydawca:
- Polska Akademia Nauk. Czytelnia Czasopism PAN
- Tematy:
-
die roll
fine blanking
SCP-1
share speed
SHP-1
v-rings
krawędzie
wykrawanie
szybkość działania
deformacja - Opis:
- The height of the die roll, the distance of the V-ring, and the shear rate were varied with the aim of investigating the effects of the applied changes on the fine blanking line in a cold-rolled and a pickled steel sheet, referred to as SCP-1 and SHP-1, respectively. Both materials consisted primarily of a ferrite phase with small amounts of impurities including F, Mn, and Cr. The distance was found to be a very important factor in controlling the shear of the V-ring in the fine blanking process. When the position of the V-ring was set at distances of 1.5 mm and 2 mm, the die roll height increased with increasing shear speeds from 6.4 m/min to 10 and 16 m/min. Analysis of the influence of the shear rate revealed that low rates resulted in the lowest die roll heights since the flow of material was effectively inhibited.
- Źródło:
-
Archives of Metallurgy and Materials; 2015, 60, 2B; 1397-1402
1733-3490 - Pojawia się w:
- Archives of Metallurgy and Materials
- Dostawca treści:
- Biblioteka Nauki
Artykuł