Informacja

Drogi użytkowniku, aplikacja do prawidłowego działania wymaga obsługi JavaScript. Proszę włącz obsługę JavaScript w Twojej przeglądarce.

Wyszukujesz frazę "Muszyński-Huhajło, M." wg kryterium: Autor


Wyświetlanie 1-3 z 3
Tytuł:
Accurate oxygen transfer efficiency measurements by off-gas method - tank coverage dilemma
Pomiar sprawności transferu tlenu metodą off-gas - problem stopnia pokrycia reaktora
Autorzy:
Muszyński-Huhajło, M.
Janiak, K.
Powiązania:
https://bibliotekanauki.pl/articles/126006.pdf
Data publikacji:
2017
Wydawca:
Towarzystwo Chemii i Inżynierii Ekologicznej
Tematy:
wastewater treatment
aeration
oxygen transfer efficiency
off-gas method
oczyszczanie ścieków
napowietrzanie
stopień wykorzystania tlenu
metoda off-gas
Opis:
The off-gas method is one of two primary aeration efficiency examination methods. In off-gas method, exhaust air from aeration tank is collected by a floating hood and conveyed to a measurement module. In this part of the installation, gas flow is measured, collected air is dried, stripped of CO2 and subsequently oxygen concentration is measured. The hood area is usually few square meters or even less and is a very small part of the aeration tank area. The main advantage of the off-gas method is that it offers measurement without disturbances to reactor routine work, which are necessary in the case of alternative, absorption method. Thereby, the off-gas method can be used in any circumstances and is free from uncertainty about the influence of reactor disturbances on the obtained results. However, a question remains about the number of measurement points required to obtain representative results for the whole reactor. According to The Environmental Protection Agency (EPA) guidelines, coverage of 2% of the tank area is sufficient, but this number seems insufficient. This article presents an analysis of the influence of tank coverage on the obtained oxygen transfer efficiency values. The presented analysis is based on real data.
Pomiary off-gas są jedną z dwóch dostępnych metod określenia stopnia wykorzystania tlenu w systemach napowietrzania oczyszczalni ścieków. Największą zaletą prezentowanej metody jest możliwość prowadzenia pomiarów w warunkach procesowych bez ingerencji w funkcjonowanie układu oczyszczania ścieków. Na podstawie danych zebranych podczas pomiarów wykonanych na jednej z komunalnych oczyszczalni ścieków w Polsce przeprowadzono analizę wpływu ilości punktów pomiarowych na uzyskiwane wartości stopnia wykorzystania tlenu. Analizę przeprowadzono, wykorzystując wyniki uzyskane z pomiarów zapewniających dużo wyższe pokrycie powierzchni reaktora (odpowiednio 12 i 8,8%) względem wytycznych literaturowych mówiących o 2% stopniu pokrycia reaktora.
Źródło:
Proceedings of ECOpole; 2017, 11, 1; 45-53
1898-617X
2084-4557
Pojawia się w:
Proceedings of ECOpole
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Failure of the side-stream deammonification process. Risk of violation of the WWTP effluent quality
Autorzy:
Janiak, J.
Miodoński, S.
Muszyński-Huhajło, M.
Powiązania:
https://bibliotekanauki.pl/articles/207349.pdf
Data publikacji:
2018
Wydawca:
Politechnika Wrocławska. Oficyna Wydawnicza Politechniki Wrocławskiej
Tematy:
activated sludge process
effluents
wastewater treatment
water quality
proces osadu czynnego
ścieki
oczyszczanie ścieków
jakość wody
Opis:
Stable and efficient nitrogen removal is one of main goals of wastewater treatment. Applying deammonification, beyond many advantages, results in the risk of the WWTP effluent quality violation in case of the failure of the process. Then nitrogen load to activated sludge is increasing rapidly which could therefore lead to quality violation in activated sludge effluent. Simulation studies have been presented on the effect of deammonification failure on nitrogen removal performance in the case of a typical, medium sized WWTP (ca. 115 000 PE). The studies were based on the calibrated ASMI model of real WWTP and a fictional scenario of implementing deammonification and subsequent failure. Implementing deammonification enables SR T optimization of the sludge retention time (SRT) in its main line thanks to lower nitrogen load. Two scenarios have been shown, considering or not optimization of the SRT in WWTP. The results show that SRT optimization leads to decrease in nitrifier mass and raises difficult issues in appropriate nitrogen concentration in the effluent.
Źródło:
Environment Protection Engineering; 2018, 44, 2; 169-179
0324-8828
Pojawia się w:
Environment Protection Engineering
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Impact of nitrification rate test procedure on results in activated sludge tests
Wpływ metodyki pomiarów szybkości nitryfikacji osadu czynnego na uzyskiwane wyniki
Autorzy:
Miodoński, S.
Muszyński-Huhajło, M.
Rucka, K.
Powiązania:
https://bibliotekanauki.pl/articles/125744.pdf
Data publikacji:
2018
Wydawca:
Towarzystwo Chemii i Inżynierii Ekologicznej
Tematy:
wastewater treatment
nitrification
nitrification rate tests
oczyszczanie ścieków
nitryfikacja
test szybkości nitryfikacji
Opis:
Nitrification is one of the fundamental biological processes in wastewater treatment and key element of nitrogen removal processes. It is not only used in traditional way of treatment with denitrification, but also in advanced processes for dewatering liquor side-stream treatment technologies. Like other biological processes, nitrification effectivity may be affected by number of factors such as amount of nitrifiers, substrate and oxygen availability and possible presence of inhibitors. According to these facts, only way to gain information about process dynamics is analytical nitrification rate test performance. Available guidelines focus on test conditions and analytical tools that should be used without any advice for number of results required to estimate accurate nitrification rate. High number of results needed in single nitrification rate test reflects in higher efforts and test costs. In this paper, over 100 nitrification rate tests results were analysed. Tests were performed in recent years on many wastewater treatment plants in Poland on activated sludge from different processes from main and side-stream treatment installations, where full or partial nitrification were used as a way of N-removal. Created database was used to define how big impact on overall nitrification rate has number and interval of results in performed test.
Nitryfikacja, jako jedna z podstawowych przemian azotu w przyrodzie, odgrywa również istotną rolę w technologii oczyszczania ścieków. Podobnie jak pozostałe procesy biochemiczne, istnieje szereg czynników mogących w sposób niekorzystny wpływać na jego przebieg. Jedną z metod monitoringu efektywności procesu jest wykonywanie testów szybkości nitryfikacji, polegających na monitoringu analitycznym wybranych form azot i określeniu ich zmienności w czasie. W celu określenia wpływu czasu trwania testu i częstotliwości wykonywania oznaczeń przeanalizowano wyniki ponad 100 testów szybkości nitryfikacji. Bazowe dane pochodziły z prac prowadzonych na rzeczywistych obiektach z tradycyjną nitryfikacją-denitryfikacją, jak również w układach do skróconej i częściowej nitryfikacji odcieków po odwadnianiu osadów.
Źródło:
Proceedings of ECOpole; 2018, 12, 1; 41-49
1898-617X
2084-4557
Pojawia się w:
Proceedings of ECOpole
Dostawca treści:
Biblioteka Nauki
Artykuł
    Wyświetlanie 1-3 z 3

    Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies