Informacja

Drogi użytkowniku, aplikacja do prawidłowego działania wymaga obsługi JavaScript. Proszę włącz obsługę JavaScript w Twojej przeglądarce.

Wyszukujesz frazę "temperatura średnia" wg kryterium: Temat


Wyświetlanie 1-3 z 3
Tytuł:
A Comparison of Skin Temperatures and Clothing Microclimate During Moderate Intermittent Exercise in the Cold Between One and Two Layers of Cotton and Polypropylene Underwear
Autorzy:
Ha, M.
Tokura, H.
Yoden, K.
Holmer, I.
Powiązania:
https://bibliotekanauki.pl/articles/90615.pdf
Data publikacji:
1998
Wydawca:
Centralny Instytut Ochrony Pracy
Tematy:
mean skin temperature
clothing microclimate
cotton
polypropylene
underwear
średnia temperatura skóry
bawełna
ubranie
polipropylen
Opis:
The purpose of this study was to compare the effects of 2 kinds of underwear made from hydrophobic and hydrophilic fabrics on the mean skin temperatures and clothing microclimate (temperature, humidity) in participants performing intermittent exercise in cold environmental conditions. One or 2 layers of cotton underwear (C1, C2) with a 2-piece long-sleeved shirt and long-legged trousers, and 1 or 2 layers of polypropylene underwear (P1, P2) with a 2-piece long-sleeved shirt and long-legged trousers were used as experimental underwear. In addition, the participants wore a 2-piece ski suit as 100% polyester clothing including 100% polyester padding. Ten young adult females volunteered as participants. The experiments were performed in a climatic chamber at an ambient temperature (Ta) of 0°C and an air velocity of 0.26 m s-1. The major findings are summarized as follows: (a) Although the clothing microclimate humidity was not different within the ski suit of outer clothing between C1 and P1, it was significantly higher in P2 than in C2; (b) Clothing microclimate temperature inside the ski suit did not differ between C1 and P1, whereas it was significantly higher in P2 than in C2; (c) The thermal gradient between innermost and outermost of clothing microclimate at back level did not show any difference between C1 and P1, but it was significantly higher in C2 than in P2. These results are discussed in terms of thermal physiology and clothing sciences.
Źródło:
International Journal of Occupational Safety and Ergonomics; 1998, 4, 3; 347-362
1080-3548
Pojawia się w:
International Journal of Occupational Safety and Ergonomics
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Analysis of the average fire gas temperature in a mine drift with multiple fires
Autorzy:
Hansen, R.
Powiązania:
https://bibliotekanauki.pl/articles/91997.pdf
Data publikacji:
2018
Wydawca:
Główny Instytut Górnictwa
Tematy:
multiple fires
mine drifts
average fire gas temperature
pożary wielokrotne
chodniki kopalniane
średnia temperatura gazu pożarowego
Opis:
The average fire gas temperature of multiple fires in a mine drift with longitudinal ventilation is investigated. The output of a quasi-steady model is investigated and compared with experimental results from model scale fire experiments. During the analysis it was found that the calculated average fire gas temperature of the model correlates quite well with the measured temperature, except for the period when the fire closest to the measuring point reached a peak of heat release rate. This poor correlation is likely due to flame impingement as the distance to the nearest fire decreases. Uncertainty of the calculations is caused by the fire gas temperature at the site of each individual fire and further studies into the fire growth rate and maximum heat release rates of multiple fires are recommended in order to remedy this uncertainty. When calculating the average fire gas temperature, a key parameter is determined with respect to the smoke spread in a mine drift as well as the risk of fire spread.
Źródło:
Journal of Sustainable Mining; 2018, 17, 4; 226-238
2300-1364
2300-3960
Pojawia się w:
Journal of Sustainable Mining
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Modified single-zone model of radiation recuperator with microfinned surface
Zmodyfikowany jednostrefowy model rekuperatora radiacyjnego z mikroużebrowaniem
Autorzy:
Karczewski, K.
Powiązania:
https://bibliotekanauki.pl/articles/264323.pdf
Data publikacji:
2007
Wydawca:
Akademia Górniczo-Hutnicza im. Stanisława Staszica w Krakowie. Wydawnictwo AGH
Tematy:
rekuperator
powierzchnia mikroużebrowana
moc cieplna
strumień ciepła
średnia ważona temperatura
recuperator
microfinned surface
heat transfer rate
heat flux
weight mean temperature
Opis:
Modified single-zone model of radiation recuperator with microfinned surface were elaborated. In this model the researches of heat transfer and hydraulic resistance microfinned elements were applied. To calculate the recuperator wall temperature weight mean temperature was used. By elaborated model radiation recuperator with microfinned surface to glass furnace were calculated. Single-zone model makes possible the project of small overall dimensions recuperators to industrial furnaces.
Opracowano zmodyfikowany jednostrefowy model rekuperatora radiacyjnego z mikroużebrowaniem. W modelu wykorzystano badania wymiany ciepła i oporów przepływu mikroużebrowanych elementów rekuperatorowych. Temperaturę ścianki przegrody rekuperatora obliczono średnią ważoną. Według opracowanego modelu zaprojektowano rekuperator radiacyjny z mikroużebrowaniem do pieca szklarskiego. Model jednostrefowy umożliwia projektowanie małych gabarytowo rekuperatorów radiacyjnych do pieców przemysłowych.
Źródło:
Metallurgy and Foundry Engineering; 2007, 33, 2; 129-139
1230-2325
2300-8377
Pojawia się w:
Metallurgy and Foundry Engineering
Dostawca treści:
Biblioteka Nauki
Artykuł
    Wyświetlanie 1-3 z 3

    Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies