Informacja

Drogi użytkowniku, aplikacja do prawidłowego działania wymaga obsługi JavaScript. Proszę włącz obsługę JavaScript w Twojej przeglądarce.

Wyszukujesz frazę "output voltage" wg kryterium: Temat


Wyświetlanie 1-7 z 7
Tytuł:
FPGA-based control of output voltage of SRG drive system
Autorzy:
Powrózek, A.
Powiązania:
https://bibliotekanauki.pl/articles/141099.pdf
Data publikacji:
2018
Wydawca:
Polska Akademia Nauk. Czytelnia Czasopism PAN
Tematy:
switched reluctance generator
single-pulse mode
output voltage control
FPGA-based control
Opis:
The paper presents an FPGA-based output voltage control system of a fourphase switched reluctance generator above base speed. The presented control strategy uses a digital PI controller to vary turn-off angle at fixed turn-on angle under single-pulse mode. Simulation tests were conducted based on the simulation model built in the Matlab/Simulink environment. The results of the simulation and laboratory tests as waveforms of voltages and currents are presented. Based on the presented control system, the dependencies of overall efficiency in the function of turn-on angle and ratio of output power to rms phase current (Pout av=Iph rms) in the function of turn-on angle were determined. They allow for the selection of a proper value of turn-on angle for the optimal performance of the generator during the output voltage control. The results obtained from laboratory and simulation tests are discussed in the conclusions.
Źródło:
Archives of Electrical Engineering; 2018, 67, 1; 95-108
1427-4221
2300-2506
Pojawia się w:
Archives of Electrical Engineering
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Proposal of the criterion for transmission line lumped parameters analysis
Autorzy:
Spałek, D.
Powiązania:
https://bibliotekanauki.pl/articles/200150.pdf
Data publikacji:
2019
Wydawca:
Polska Akademia Nauk. Czytelnia Czasopism PAN
Tematy:
transmission line
lumped parameters analysis
no-load output voltage change
adjustable criterion
Opis:
The paper concerns the problem of choosing a criterion for transmission line when lumped parameters analysis is required. First, the formal introduction of transmission line scheme is presented. Secondly, a new criterion for lumped-parameter analysis of transmission line is proposed. The criterion has clear physical meaning and simple mathematical form. The proposed criterion takes into account not only wave length, but also the dissipation of transmission line. The criterion can be easily adjusted to some requirements, such as needed level of no-load output voltage change.
Źródło:
Bulletin of the Polish Academy of Sciences. Technical Sciences; 2019, 67, 6; 1181-1186
0239-7528
Pojawia się w:
Bulletin of the Polish Academy of Sciences. Technical Sciences
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
On minimization of nonlinear distortion in Sallen and Key filter in range of low frequencies
O minimalizacji zniekształceń nieliniowych w filtrze Sallena-Key w zakresie niskich częstotliwości
Autorzy:
Borys, A.
Zakrzewski, Z.
Powiązania:
https://bibliotekanauki.pl/articles/389870.pdf
Data publikacji:
2014
Wydawca:
Politechnika Bydgoska im. Jana i Jędrzeja Śniadeckich. Wydawnictwo PB
Tematy:
Sallen and Key filter
modeling nonlinear distortion in low frequencies
operational amplifier output voltage saturation
Volterra series
gain-sensitivity product
filtr Sallena-Key
modelowanie nieliniowych zniekształceń w zakresie niskich częstotliwościach
napięciowe nasycenie wyjścia wzmacniacza operacyjnego
szeregi Volterry
iloczyn wzmocnienia i wrażliwości
Opis:
In this paper, we show that a mildly nonlinear model of an active filter using the Volterra series and any other related one do not give satisfactory results in evaluation of nonlinear distortion in the range of low frequencies, in which the operational amplifier output voltage saturation is a dominating nonlinear phenomenon in this filter. Therefore, minimization of the filter nonlinear distortion cannot be performed by minimization of the gain-sensitivity product (GSP) or the so-called distortion aggravation factor (FDAG) in the aforementioned range of frequencies. This is illustrated, using measured data of filter transfer function distortion, on an example of a low-pass Sallen and Key filter.
W niniejszym artykule pokazano, że słabo nieliniowy model aktywnego filtru wykorzystujący szereg Volterry i inne temu podobne modele, nie daje zadowalających wyników w określaniu zniekształceń nieliniowych filtru w zakresie niskich częstotliwości, w którym napięciowe nasycenie na wyjściu wzmacniacza operacyjnego stanowi podstawowe zjawisko nieliniowe w tym filtrze. Konsekwencją tego jest to, że minimalizacja zniekształceń nieliniowych filtru nie może być wtedy oparta o minimalizację takich miar jak, na przykład, iloczyn wzmocnienia i wrażliwości, czy też odwrotność współczynnika sprzężenia w wyżej wspomnianym zakresie częstotliwości. Zostało to wykazane przy pomocy pomiarowych danych zniekształceń funkcji przenoszenia filtru, na przykładzie dolnoprzepustowego filtru Sallena-Key.
Źródło:
Zeszyty Naukowe. Telekomunikacja i Elektronika / Uniwersytet Technologiczno-Przyrodniczy w Bydgoszczy; 2014, 18; 5-10
1899-0088
Pojawia się w:
Zeszyty Naukowe. Telekomunikacja i Elektronika / Uniwersytet Technologiczno-Przyrodniczy w Bydgoszczy
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Analysis of operation of class E ZVS resonant inverter
Autorzy:
Szychta, E.
Powiązania:
https://bibliotekanauki.pl/articles/262645.pdf
Data publikacji:
2005
Wydawca:
Akademia Górniczo-Hutnicza im. Stanisława Staszica w Krakowie
Tematy:
class E ZVS resonant
inverter
output capacitance
MOSFET transistor
zero voltage switching
Opis:
The article discusses class E zero-voltage-switching resonant inverter (ZVS). The resonant circuit of the inverter is subject to mathematical analysis using the method of state variables with the aid of MATLAB software. Results of simulation testing, based on Simplorer software, of an inverter at the operating frequency of 100kHz are presented.
Źródło:
Electrical Power Quality and Utilisation. Journal; 2005, 11, 1; 57-67
1896-4672
Pojawia się w:
Electrical Power Quality and Utilisation. Journal
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Relationship between the number of Monte Carlo trials applied for modelling voltage output accelerometers and the maximum dynamic errors
Zależność pomiędzy liczbą prób Monte Carlo w modelowaniu akcelerometrów z wyjściem napięciowym a maksymalnymi błędami dynamicznymi
Autorzy:
Tomczyk, K.
Powiązania:
https://bibliotekanauki.pl/articles/268102.pdf
Data publikacji:
2016
Wydawca:
Politechnika Gdańska. Wydział Elektrotechniki i Automatyki
Tematy:
Monte Carlo trials
maximum distance criterion
voltage output accelerometer
Box-Muller pseudo-random number generator
próby Monte Carlo
kryterium maksymalnej odległości
akcelerometr z wyjściem napięciowym
generator liczb pseudo-losowych Boxa-Mullera
Opis:
This paper examines the influence of the number of Monte Carlo trials on the maximum dynamic errors. These trials were used for modelling voltage output accelerometers, while the errors were represented by the maximum distance criterion. A weighted least-squares method that is based on a Monte Carlo adaptive procedure was used for accelerometer modelling. The subsequent Monte Carlo trials were provided by the Box-Muller pseudo-random number generator. As an example, modelling of the Endevco87 accelerometer based on the measurement points of its frequency characteristics was presented. Then, the errors corresponding to the input signals with one and two constraints were determined. Finally, the relationship between the number of Monte Carlo trials and the values of maximum dynamic errors was assessed. Modelling of the accelerometer was carried out in MATLAB14, while the maximum errors were determined using MathCad15. For calculations, the following personal computer was used: 64 bits AMD processor 3.4 GHz and 32 GB RAM.
Artykuł przedstawia analizę wpływu liczby prób Monte Carlo na wartości maksymalnych błędów dynamicznych. Próby te zastosowano do modelowania akcelerometrów z wyjściem napięciowym, natomiast błędy wyrażono za pomocą kryterium maksymalnej odległości. Do modelowania akcelerometrów zastosowano ważoną metodę najmniejszych kwadratów wykorzystującą adaptacyjną procedurę Monte Carlo. Kolejne próby Monte Carlo zostały wygenerowane za pomocą generatora liczb pseudo-losowych Boxa-Mulllera. W oparciu o punkty pomiarowe charakterystyk częstotliwościowych, przedstawiono procedurę modelowania akcelerometru Endevco87. Następnie wyznaczono błędy odpowiadające sygnałom wejściowym z jednym i z dwoma ograniczeniami. Na końcu oceniono zależność pomiędzy liczbą prób Monte Carlo a wartościami maksymalnych błędów dynamicznych. Modelowanie akcelerometru zrealizowano w programie MATAB14, natomiast maksymalne błędy wyznaczono w programie MathCad15.
Źródło:
Zeszyty Naukowe Wydziału Elektrotechniki i Automatyki Politechniki Gdańskiej; 2016, 49; 113-116
1425-5766
2353-1290
Pojawia się w:
Zeszyty Naukowe Wydziału Elektrotechniki i Automatyki Politechniki Gdańskiej
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Positive output elementary Luo converter for fixed-frequency ZVS operation
Autorzy:
Bright, S. J. V.
Ramkumar, S.
Anand, H.
Powiązania:
https://bibliotekanauki.pl/articles/200011.pdf
Data publikacji:
2017
Wydawca:
Polska Akademia Nauk. Czytelnia Czasopism PAN
Tematy:
fixed-frequency ZVS
positive output elementary Luo converter
POELC
zero-voltage switching-pulse width modulation
ZVS-PWM
konwerter Luo
ZVS
Opis:
Luo converter is one amid the developed DC-DC converters offering higher voltage gain. Soft-switching techniques, like zero-voltage switching (ZVS), repress switching losses, and hence the system efficiency and the life of the power semiconductor switches are improved. Incorporation of soft switching in fixed-frequency operation of the Luo converters may persuade them in the regulated power supply applications. The existing variable switching frequency solution suffers from a number of problems viz. complexity in filter designing, more electromagnetic interference (EMI), etc. This paper proposes a positive output elementary Luo converter (POELC) involving ZVS with the wherewithal of working in fixed frequency. A comprehensive discussion on the proposed circuit topology is detailed with both simulation and experimental studies. Systematic descriptions of basic POELC, variable-frequency ZVS-POELC, and fixed-frequency ZVS-POELC make an impact on the understanding of related concepts by the researchers in this field.
Źródło:
Bulletin of the Polish Academy of Sciences. Technical Sciences; 2017, 65, 2; 255-262
0239-7528
Pojawia się w:
Bulletin of the Polish Academy of Sciences. Technical Sciences
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Designing and Modeling of Control Strategies Based on Multi-Objective Optimization for a PMSG Wind Turbine: A Study Based on the Grid Errors and Wind Speed
Autorzy:
Ganji, Ehsan
Mahdavian, Mehdi
Eshaghpour, Iman
Janghorban, Mojtaba
Powiązania:
https://bibliotekanauki.pl/articles/102412.pdf
Data publikacji:
2019
Wydawca:
Stowarzyszenie Inżynierów i Techników Mechaników Polskich
Tematy:
wind turbine
permanent magnet synchronous generator (PMSG)
output stability of the turbine
resistive depletion load
voltage damping
reduction of switching harmonics
turbina wiatrowa
generator synchroniczny z magnesem trwałym (PMSG)
stabilność wyjściowa turbiny
Opis:
In this paper, an independent wind energy conversion system was studied with the control strategies used to provide power specifically to the areas far from the grid. In this research, three strategies are designed and used in order to stabilize the output. This system contains a directed rectifier which is responsible for maximum power point tracking. Additionally, a common DC bus and a fully controlled inverter were designed. An LC filter was also used in the system in order to eliminate switching harmonics to a considerable extent and provide a reliable noiseless source for load supply. Since the power demand and the produced power of the turbine are variable and indistinguishable in each moment, a depletion load is also placed in the system. In this study, it was observed that the designed strategies prove the output stability in different sections and under different conditions with resonators and non-linear PI and PID controllers. The designed strategies were also supported by the simulation results.
Źródło:
Advances in Science and Technology. Research Journal; 2019, 13, 4; 60-69
2299-8624
Pojawia się w:
Advances in Science and Technology. Research Journal
Dostawca treści:
Biblioteka Nauki
Artykuł
    Wyświetlanie 1-7 z 7

    Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies