Informacja

Drogi użytkowniku, aplikacja do prawidłowego działania wymaga obsługi JavaScript. Proszę włącz obsługę JavaScript w Twojej przeglądarce.

Wyszukujesz frazę "Turyanytsa, I." wg kryterium: Autor


Wyświetlanie 1-2 z 2
Tytuł:
Influence of the Introduction of Copper into Amorphous $As_2Se_3$ Matrix on Its Thermal and Structural Characteristics
Autorzy:
Štrbac, G.
Lukić-Petrović, S.
Štrbac, D.
Čajko, K.
Turyanytsa, I.
Powiązania:
https://bibliotekanauki.pl/articles/1399717.pdf
Data publikacji:
2013-02
Wydawca:
Polska Akademia Nauk. Instytut Fizyki PAN
Tematy:
64.70.kj
64.70.P-
65.60.+a
Opis:
This paper describes the results of the determination of some thermal and structural parameters of glasses from the $Cu_{x}(As_2Se_3)_{100-x}$ system for x=0, 1, 5, 10 and 15 at.%. Based on the differential scanning calorimetry curves taken at different heating rates, glass transition temperature $T_{g}$, onset temperature of crystallization $T_{onset}$, and melting temperature $T_{m}$ of crystalline units formed are determined. The values of activation energy $E_{g}$ of glass transition process are calculated. These characteristic temperatures served as the basis for the calculation of the parameters of thermal stability of the glasses towards crystallization.
Źródło:
Acta Physica Polonica A; 2013, 123, 2; 256-258
0587-4246
1898-794X
Pojawia się w:
Acta Physica Polonica A
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Mechanical Characteristics of As₂S₃ Glasses Induced by Doping with Bismuth
Autorzy:
Šiljegović, M.
Lukić-Petrović, S.
Petrović, D.
Videnović, I.
Turyanytsa, I.
Powiązania:
https://bibliotekanauki.pl/articles/1398705.pdf
Data publikacji:
2016-04
Wydawca:
Polska Akademia Nauk. Instytut Fizyki PAN
Tematy:
61.43.Fs
62.20.-x
62.20.D-
64.75.Gh
Opis:
This paper presents and discusses the results of the instrumented indentation test of the samples of the system $Bi_{x}(As₂S₃)_{100-x}$, x= 1.5, 3, 5, and 7 at.%. Measurements of mechanical parameters were performed using a Fischerscope HM2000 S nanoindentation device. The experimental data obtained by measuring the microhardness parameters were used to determine some other mechanical quantities that are important for the characterization of the examined materials in terms of their potential applications. For the first three compositions, the results indicated an increase in the microhardness with the increase in the content of doping atoms, which can be interpreted as an enhancement of the strength and stiffness of the structural network. The lower value of microhardness of the sample with the maximum content of Bi can BE associated with the specific structure of this composition. The pronounced indentation size effect was also detected on the indentation curve in the range of smaller loads. According to the model of elastic-plastic deformation, applied for the description of indentation size effect measured for the investigated chalcogenides, the largest value of the elastic recovery was observed for the sample Bi₇(As₂S₃)₉₃. The calculated values of the elasticity modulus show that the glass with x= 5 at.% Bi is characterized with the highest atomic packing density.
Źródło:
Acta Physica Polonica A; 2016, 129, 4; 488-491
0587-4246
1898-794X
Pojawia się w:
Acta Physica Polonica A
Dostawca treści:
Biblioteka Nauki
Artykuł
    Wyświetlanie 1-2 z 2

    Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies