Informacja

Drogi użytkowniku, aplikacja do prawidłowego działania wymaga obsługi JavaScript. Proszę włącz obsługę JavaScript w Twojej przeglądarce.

Wyszukujesz frazę "Pietrowski, M." wg kryterium: Autor


Wyświetlanie 1-4 z 4
Tytuł:
Nanocolloidal Ru/MgF2 Catalyst for Hydrogenation of Chloronitrobenzene and Toluene
Autorzy:
Pietrowski, M.
Zieliński, M.
Wojciechowska, M.
Powiązania:
https://bibliotekanauki.pl/articles/779536.pdf
Data publikacji:
2014
Wydawca:
Zachodniopomorski Uniwersytet Technologiczny w Szczecinie. Wydawnictwo Uczelniane ZUT w Szczecinie
Tematy:
ruthenium nanocolloidal catalyst
magnesium fluoride
toluene hydrogenation
reduction of chloronitrobenzene
Opis:
The use of magnesium fluoride support for ruthenium active phase allowed obtaining new catalysts of high activities in the hydrogenation of toluene and ortho-chloronitrobenzene. Ruthenium colloid catalysts (1 wt.% of Ru) were prepared by impregnation of the support with the earlier produced polyvinylpyrrolidone (PVP)-stabilized ruthenium colloids. The performances of the colloidal catalysts and those obtained by traditional impregnation were tested in the reactions of toluene hydrogenation to methylcyclohexane and selective hydrogenation of ortho-chloronitrobenzene (o-CNB) to ortho-chloroaniline (o-CAN). It was shown that the use of chemical reduction method allows obtaining highly monodisperse ruthenium nanoparticles of 1.6–2.6 nm in size. After reduction in hydrogen at 400oC, the colloidal ruthenium nanoparticles were found to strongly interact with MgF2 surface (SMSI), which decreased the catalyst ability to hydrogen chemisorption, but despite this, the colloid catalysts showed higher activity in o-CNB hydrogenation and higher selectivity to o-CAN than the traditional ones. It is supposed that their higher activity can be a result of high dispersion of Ru in colloid catalysts and the higher selectivity can be a consequence of the lower availability of hydrogen on the surface.
Źródło:
Polish Journal of Chemical Technology; 2014, 16, 2; 63-68
1509-8117
1899-4741
Pojawia się w:
Polish Journal of Chemical Technology
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Methane fermentation of chicken droppings
Fermentacja metanowa pomiotu kurzego
Autorzy:
Lewicki, A.
Kozłowski, K.
Pietrowski, M.
Zbytek, Z.
Powiązania:
https://bibliotekanauki.pl/articles/335881.pdf
Data publikacji:
2016
Wydawca:
Sieć Badawcza Łukasiewicz - Przemysłowy Instytut Maszyn Rolniczych
Tematy:
biogas
chicken droppings
ammonium inhibition
biogaz
pomiot drobiowy
inhibicja amonowa
Opis:
The most troublesome waste from the poultry industry is the manure produced in Poland in the amount of 2.5 million tons per year. It is a substrate with high energy potential whose potential is, however, used very little. Research conducted at the Institute of Biosystems Engineering at the University of Life Sciences in Poznan showed that the biogas efficiency of substrate is 121.40 m3⋅Mg - 1 fresh matter but also point to limitations in the use of the substrate for the purpose of biogas. Observed in the process of continuous fermentation of ammonium inhibition, inhibiting methane fermentation process, it has been defined for the concentration of ammonia nitrogen at 3.7 g·dm - 3 fresh matter.
Najbardziej uciążliwym odpadem z przemysłu drobiowego jest pomiot kurzy produkowany w Polsce w ilości 2,5 mln ton rocznie. Jest to substrat o dużym potencjale energetycznym, którego potencjał jest jednak wykorzystywany w bardzo niewielkim stopniu. Badania przeprowadzone w Instytucie Inżynierii Biosystemów Uniwersytetu Przyrodniczego w Poznaniu wykazały wydajności biogazową substratu na poziomie 121,4 m3⋅Mg -1 świeżej masy, ale także wskazały ograniczenia w wykorzystaniu tego substratu na cele biogazowe. Zaobserwowany w procesie fermentacji ciągłej proces inhibicji amonowej, hamującej proces fermentacji metanowej, został zaobserwowany przy stężeniu azotu amonowego na poziomie 3,7 g·dm-3 św. m.
Źródło:
Journal of Research and Applications in Agricultural Engineering; 2016, 61, 4; 28-30
1642-686X
2719-423X
Pojawia się w:
Journal of Research and Applications in Agricultural Engineering
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Spectral analysis of phase currents of LSPMSM at asymmetric voltage supply
Spektralna analiza prądów stojana silnika LSPMSM przy niesymetrycznym zasilaniu
Autorzy:
Idziak, P.
Nowak, M.
Pietrowski, W.
Powiązania:
https://bibliotekanauki.pl/articles/972163.pdf
Data publikacji:
2013
Wydawca:
Stowarzyszenie Inżynierów i Techników Mechaników Polskich
Tematy:
power supply asymmetry
synchronous motor
permanent magnets
niesymetria zasilania
silnik synchroniczny
magnesy trwałe
Opis:
This paper presents a spectral analysis of the stator currents at power supply asymmetry of the line start synchronous motor with permanent magnets. The study was conducted for various levels of asymmetry of motor voltage and different values of load. The tested motor was developed in the Department of Mechatronics and Electrical Machines at Poznan University of Technology. The construction of the stator is based on the mass-produced four-pole, three-phase induction motor type Sg100L-4B. The examined motor has rotor with u-shaped permanent magnets. In order to control the level of asymmetry of the motor voltage supply, the system was supplied from three auto-transformers. The voltage in one phase varied in the range from -10% to +10% of rated value. To adjust the value of the load motor was connected with the eddy current brake.
W artykule przedstawiona została analiza spektralna prądów stojana przy niesymetrii zasilania silnika synchronicznego z magnesami trwałymi o rozruchu bezpośrednim. Badania przeprowadzono dla różnego stopnia niesymetrii napięcia zasilającego silnik oraz różnych wartości obciążenia silnika. Badany silnik został opracowany w Zakładzie Mechatroniki i Maszyn Elektrycznych Politechniki Poznańskiej. Konstrukcję stojana oparto na bazie seryjnie produkowanego czterobiegunowego, trójfazowego silnika indukcyjnego typu Sg100L-4B. Rozpatrywany silniki ma w wirniku klatkę rozruchową oraz magnesy trwałe rozmieszczone w formie litery „U”. W celu regulacji stopnia niesymetrii układ silnik zasilany był z trzech autotransformatorów. Napięcie w jednej z faz zmieniano w granicach od -10% do +10% wartości znamionowej. Aby regulować wartość obciążenia silnik sprzężono z hamulcem wiroprądowym. Do rejestracji i archiwizacji danych zastosowano system komputerowy z kartą pomiarową National Instruments NI PCI-6123 oraz oprogramowaniem LabVIEW.
Źródło:
Pomiary Automatyka Kontrola; 2013, R. 59, nr 10, 10; 1032-1035
0032-4140
Pojawia się w:
Pomiary Automatyka Kontrola
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Methods of Estimating the Effect of Integral Motorcycle Helmets on Physiological and Psychological Performance
Autorzy:
Bogdan, A.
Sudoł-Szopińska, I.
Łuczak, A.
Konarska, M.
Pietrowski, P.
Powiązania:
https://bibliotekanauki.pl/articles/90624.pdf
Data publikacji:
2012
Wydawca:
Centralny Instytut Ochrony Pracy
Tematy:
integral helmet
motorcyclist thermophysiology
motorcyclist
cognitive functions
physiological response
Opis:
This article proposes a method for a comprehensive assessment of the effect of integral motorcycle helmets on physiological and cognitive responses of motorcyclists. To verify the reliability of commonly used tests, we conducted experiments with 5 motorcyclists. We recorded changes in physiological parameters (heart rate, local skin temperature, core temperature, air temperature, relative humidity in the space between the helmet and the surface of the head, and the concentration of O2 and CO2 under the helmet) and in psychological parameters (motorcyclists’ reflexes, fatigue, perceptiveness and mood). We also studied changes in the motorcyclists' subjective sensation of thermal comfort. The results made it possible to identify reliable parameters for assessing the effect of integral helmets on performance, i.e., physiological factors (head skin temperature, internal temperature and concentration of O2 and CO2 under the helmet) and on psychomotor factors (reaction time, attention and vigilance, work performance, concentration and a subjective feeling of mood and fatigue).
Źródło:
International Journal of Occupational Safety and Ergonomics; 2012, 18, 3; 329-342
1080-3548
Pojawia się w:
International Journal of Occupational Safety and Ergonomics
Dostawca treści:
Biblioteka Nauki
Artykuł
    Wyświetlanie 1-4 z 4

    Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies