Informacja

Drogi użytkowniku, aplikacja do prawidłowego działania wymaga obsługi JavaScript. Proszę włącz obsługę JavaScript w Twojej przeglądarce.

Wyszukujesz frazę "Załęski, K." wg kryterium: Autor


Wyświetlanie 1-4 z 4
Tytuł:
Positron Annihilation in Steel Burnished by Vibratory Shot Peening
Autorzy:
Zaleski, R.
Zaleski, K.
Powiązania:
https://bibliotekanauki.pl/articles/2047165.pdf
Data publikacji:
2006-11
Wydawca:
Polska Akademia Nauk. Instytut Fizyki PAN
Tematy:
78.70.Bj
71.60.+z
62.20.Fe
62.20.Mk
81.20.Wk
81.40.-z
81.70.-q
81.05.Bx
Opis:
A series of C45 steel samples was burnished by shot peening with varying time of treatment. The samples were investigated by nondestructive positron annihilation techniques: angular correlations of two-quantum annihilation radiation and positron annihilation lifetime spectroscopy. To determine residual stresses present under burnished surface the same samples were studied by destructive Davidenkov method. Change of absolute value of the weighted average of residual stresses over positron range in the series of the samples is in good agreement with change of S/W ratio obtained by angular correlations of two-quantum annihilation radiation. Both parameters increase during first 10 minutes of shot peening and then stabilize. Positron annihilation lifetime spectra allowed to identify two types of structural defects: smaller ones like vacancies or dislocations and bigger - probably clusters of vacancies. Increase in shot peening time causes reduction of positron trapping rate and lifetime rise in bigger defects.
Źródło:
Acta Physica Polonica A; 2006, 110, 5; 739-746
0587-4246
1898-794X
Pojawia się w:
Acta Physica Polonica A
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Positron annihilation lifetime spectroscopy study of roller burnished magnesium alloy
Autorzy:
Zaleski, R.
Zaleski, K.
Gorgol, M.
Powiązania:
https://bibliotekanauki.pl/articles/146650.pdf
Data publikacji:
2015
Wydawca:
Instytut Chemii i Techniki Jądrowej
Tematy:
AZ91HP magnesium alloy
defects
positron lifetime annihilation spectroscopy (PALS)
roller burnishing
Vickers hardness test
Opis:
The effect of roller burnishing on Vickers’ hardness and positron lifetimes in the AZ91HP magnesium alloy was studied. The microhardness increases with an increase in the burnishing force and with a decrease in the feed. The comparison of various methods of analysis of positron annihilation lifetime (PAL) spectra allowed identification of two components, which are related to solute-vacancy complexes and vacancy clusters, respectively. It was found that the increase in microhardness was related to the increase in the concentration of vacancy clusters.
Źródło:
Nukleonika; 2015, 60, No. 4, part 1; 789-794
0029-5922
1508-5791
Pojawia się w:
Nukleonika
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Impact of Impulse Shot Peening Parameters on Properties of Stainless Steel Surface
Autorzy:
Wiertel, M.
Zaleski, K.
Gorgol, M.
Skoczylas, A.
Zaleski, R.
Powiązania:
https://bibliotekanauki.pl/articles/1033967.pdf
Data publikacji:
2017-11
Wydawca:
Polska Akademia Nauk. Instytut Fizyki PAN
Tematy:
81.65.-b
81.20.Wk
62.20.Qp
61.72.-y
78.70.Bj
Opis:
Shot peening was applied to austenitic stainless steel 1.4541 (EN). The surface treatment was performed at various impact energies E, impact densities j and ball diameters D. This resulted in improved microhardness, which increases monotonically with the increase of E, j and 1/D. However, its changes with E and j achieve saturation at about 400 HV0.1. On the contrary, no saturation is observed in the investigated range for 1/D. In the un-shot peened 1.4541 (EN) steel, the lifetime component of low intensity was found with use of positron annihilation lifetime spectroscopy (PALS). It corresponds to positron annihilation from delocalized state of positrons in bulk. In the shot peened samples the bulk component is no longer observed. Instead, two types of defects can be identified: vacancy-like defects coupled with edge dislocations and vacancies or their small clusters (consisting 3÷5 vacancies). The results of PALS and hardness testing do not correspond very well, especially in the case of the samples shot peened with balls of varying diameters. The most probable reason for this are different depth profiles of both methods. It seems that the defects, which are responsible for the increase of static microhardness above 400 HV0.1 are located mostly below the surface layer penetrated by positrons.
Źródło:
Acta Physica Polonica A; 2017, 132, 5; 1611-1615
0587-4246
1898-794X
Pojawia się w:
Acta Physica Polonica A
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Positron annihilation lifetime spectroscopy study of thermal processing and rehydration of dry leek (Allium porrum L.)
Autorzy:
Zaleski, R.
Wawryszczuk, J.
Sobczak, K.
Powiązania:
https://bibliotekanauki.pl/articles/146309.pdf
Data publikacji:
2010
Wydawca:
Instytut Chemii i Techniki Jądrowej
Tematy:
positron annihilation
lifetime spectroscopy
food processing
rehydration
leek (Allium porrum L.)
Opis:
New application of positron annihilation lifetime spectroscopy (PALS) to development of food processing techniques is tested. Dehydrated leeks were an object of the study. Three experiments were performed consisting of evacuating air and volatile compounds from the sample, applying thermal treatment and rehydrating the sample. Distinct changes in positron lifetime spectra allowed the monitoring of alterations in the sample structure. The most likely origin of the particular components present in the spectra was able to be proposed from these data. Changes of the components were ascribed to the various processes occurring in the samples.
Źródło:
Nukleonika; 2010, 55, 1; 73-78
0029-5922
1508-5791
Pojawia się w:
Nukleonika
Dostawca treści:
Biblioteka Nauki
Artykuł
    Wyświetlanie 1-4 z 4

    Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies