Informacja

Drogi użytkowniku, aplikacja do prawidłowego działania wymaga obsługi JavaScript. Proszę włącz obsługę JavaScript w Twojej przeglądarce.

Wyszukujesz frazę "combustion engine performance" wg kryterium: Temat


Wyświetlanie 1-3 z 3
Tytuł:
Combustion, performance and exhaust emissions of the diesel engine operating on jet fuel
Autorzy:
Labeckas, G.
Slavinskas, S.
Vilutiene, V.
Powiązania:
https://bibliotekanauki.pl/articles/248056.pdf
Data publikacji:
2012
Wydawca:
Instytut Techniczny Wojsk Lotniczych
Tematy:
diesel engine
jet fuel
autoignition
combustion
performance
emissions
smoke
Opis:
The article focuses on bench testing results of a four-stroke, four-cylinder, direct-injection, naturally aspirated diesel engine operating on the normal 95vol% (class C) diesel fuel + 5vol% RME (DF), F-34 jet fuel (JF) and jet fuel F-34 treated with the cetane improver (JF+0.12vol%). The purpose of the research is to investigate the availability to use of military F-34 jet fuel for land-based direct injection diesel engine powering and examine the effect of F-34 fuel and F-34 fuel treated with 0.12vol% 2-ethylhexyl nitrate on the autoignition delay, combustion, engine performance, emissions and smoke opacity of the exhausts. The peak in-cylinder gas pressure generated from JF and JF+0.12vol% is lower by 4.3% and 2.8% at 1400 min–1 speed, and 2.5% and 5.7% at 2200 min–1 speed compared to that 86.6 MPa and 82.5 MPa of the normal diesel. At rated 2200 min–1 speed, the use of treated jet fuel leads to smoother engine performance under all loads and the maximum cylinder pressure gradient lowers by 9.4% as against that 15.9 bar/deg of base diesel. The minimum brake specific fuel consumption (bsfc) for F-34 and treated F-34 fuels decreases by 4.8% and 3.5% at 1400 min–1 speed and increases by 2.7% and 3.7% at 2200 min–1 speed compared to 249.5 g/kWh and 251.8 g/kWh values of base diesel. Maximum NO emissions produced from fuels JF and JF+0.12vol% decrease by 11.5% and 7.0% at 1400 min–1, and 17.1% and 17.3% at 2200 min–1 speed compared to 1705 ppm and 1389 ppm emanating from the normal diesel. Maximum CO emissions produced from jet fuel JF and JF+0.12vol% decrease by 39.3% and 16.8% compared to that 4988 ppm produced from base diesel running at 1400 min–1 speed. At 2200 min-1 speed, the ecological effect of using fuel F-34 fuel decreases and the CO sustains over the whole load range at the same level and increases by 2.5% and 3.0% with regard to the normal diesel operating under high load. The HC emission also is lower by 78.3% and 58.8% for low and high loads compared to 230 ppm and 1820 ppm of the normal diesel running at 1400 min–1 speed. The smoke opacity ,generated from fuels JF and JF+0.12vol% sustains at lower levels over the all load range with the maximum values decreased by 14.6% and 8.1% with regard to 94.9% of the normal diesel operating at 1400 min–1 speed. The test results show that military F-34 fuel is a cleaner-burning replacement of diesel fuel and suggests fuel economy with reduced all harmful species, including NO, NO2, NOx, CO, HC, and smoke opacity of the exhausts.
Źródło:
Journal of KONES; 2012, 19, 1; 227-236
1231-4005
2354-0133
Pojawia się w:
Journal of KONES
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
The effect of aviation fuel JP-8 and diesel fuel blends on engine performance and exhaust emissions
Autorzy:
Labeckas, G.
Slavinskas, S.
Vilutienė, V.
Powiązania:
https://bibliotekanauki.pl/articles/949492.pdf
Data publikacji:
2015
Wydawca:
Instytut Techniczny Wojsk Lotniczych
Tematy:
diesel engine
jet fuel
diesel fuel
autoignition
combustion
performance
exhaust emissions
Opis:
The article presents bench test results of a four-stroke, four-cylinder, naturally aspirated, DI diesel engine operating with neat JP-8 fuel (J) and its blends with Diesel fuel (D) in following proportions by volume: 90/10 (J+10D), 70/30 (J+D30), 50/ 50 (J+D50), 30/70 (J+D70), and 100% diesel fuel (DF). The purpose of the research was to analyse and compare changes occurred in the autoignition delay, combustion events, engine performance efficiency, emissions, and smoke of the exhaust when running on JP-8 fuel, jet-diesel fuel blends, and diesel fuel at a full (100%) engine load and speed of 1400 min–1 at which maximum torque occurs and rated speed of 2200 min–1. It was found that the start of injection (SOI) and the start of combustion (SOC) occurred earlier in an engine cycle and the autoignition delay decreased by 9.0% and 12.7% due to replacement of aviation JP-8 fuel with diesel fuel at a full load and the latter speeds. Maximum in-cylinder pressure was 6.8% and 4.0% higher when operating with diesel fuel, whereas brake thermal efficiency was 3.3% and 7.7% higher, and brake specific fuel consumption 2.8% and 7.0% lower when using fuel blend J+D50 compared with the respective values measured with neat JP-8 fuel. Emissions of nitric oxide (NO) and nitrogen oxides (NOx) were 13.3% and 13.1% higher from a straight diesel running at speed of 1400 min–1, and 19.0% and 19.5% higher at a higher speed of 2200 min–1. The carbon monoxide (CO) emissions and total unburned hydrocarbons (HC) decreased 2.1 times and by 12.3% when running with fuel blend J+D70 at speed of 2200 min–1 compared with those values measured with jet fuel. Smoke of the exhaust was 53.1% and 1.9% higher when using fuel blend J+D10 than that of 46.9% and 70.0% measured with jet fuel at speeds of 1400 and 2200 min–1. The engine produced 34.5% more smoke from combustion of fuel blend J+D70 at the low speed of 1400 min–1, but smoke converted to be 11.3% lower when operating at a higher speed of 2200 min–1.
Źródło:
Journal of KONES; 2015, 22, 2; 129-138
1231-4005
2354-0133
Pojawia się w:
Journal of KONES
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
The effect of oxygenated diesel-n-butanol fuel blends on combustion, performance, and exhaust emissions of a turbocharged crdi diesel engine
Autorzy:
Labeckas, G.
Slavinskas, S.
Rudnicki, J.
Zadrąg, R.
Powiązania:
https://bibliotekanauki.pl/articles/259929.pdf
Data publikacji:
2018
Wydawca:
Politechnika Gdańska. Wydział Inżynierii Mechanicznej i Okrętownictwa
Tematy:
diesel engine
diesel-n-butanol blends
combustion phenomenon
performance efficiency
smoke
pollutant emissions
Opis:
The article deals with the effects made by using various n-butanol-diesel fuel blends on the combustion history, engine performance and exhaust emissions of a turbocharged four-stroke, four-cylinder, CRDI 1154HP (85 kW) diesel engine. At first, load characteristics were taken when running an engine with normal diesel fuel (DF) to have ‘baseline’ parameters at the two ranges of speed of 1800 and 2500 rpm. Four a fossil diesel (class 1) and normal butanol (n-butanol) fuel blends possessing 1 wt%, 2 wt%, 3 wt%, and 4 wt% (by mass) of n-butanol-bound oxygen fractions were prepared by pouring 4.65 wt% (BD1), 9.30 wt% (BD2), 13.95 wt% (BD3), and 18.65 wt% (BD4) n-butanol to diesel fuel. Then, load characteristics were taken when an engine with n-butanol-oxygenated fuel blends at the same speeds. Analysis of the changes occurred in the autoignition delay, combustion history, the cycle-to-cycle variation, engine efficiency, smoke, and exhaust emissions NOx, CO, THC obtained with purposely designed fuel blends was performed on comparative bases with the corresponding values measured with ‘baseline’ diesel fuel to reveal the potential developing trends.
Źródło:
Polish Maritime Research; 2018, 1; 108-120
1233-2585
Pojawia się w:
Polish Maritime Research
Dostawca treści:
Biblioteka Nauki
Artykuł
    Wyświetlanie 1-3 z 3

    Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies