Informacja

Drogi użytkowniku, aplikacja do prawidłowego działania wymaga obsługi JavaScript. Proszę włącz obsługę JavaScript w Twojej przeglądarce.

Wyszukujesz frazę "Zgórniak, Piotr" wg kryterium: Autor


Wyświetlanie 1-1 z 1
Tytuł:
Chip Temperature Measurement in the Cutting Area During Rough Milling Magnesium Alloys with a Kordell Geometry End Mill
Autorzy:
Kuczmaszewski, Józef
Zagórski, Ireneusz
Zgórniak, Piotr
Powiązania:
https://bibliotekanauki.pl/articles/2172352.pdf
Data publikacji:
2022
Wydawca:
Stowarzyszenie Inżynierów i Techników Mechaników Polskich
Tematy:
magnesium alloys
milling
temperature in cutting area
chip temperature
infrared camera
Opis:
The paper presents the results of measurements of chip temperature in the cutting zone during milling. The main aim of the research was to record and compare the maximum chip temperature in consecutive frames of thermal images. An additional goal may be the influence of changes in technological parameters on the temperature of the chips in the cutting zone. Two grades of magnesium alloys were used for the tests: AZ31 and AZ91HP. The research used a carbide milling cutter with an additional chip breaker, dedicated to effective roughing of light alloys. These tool geometries can assist in the high-performance machining of magnesium alloys by efficiently splitting the chip and consequently reducing friction in the machining zone. This can reduce the cutting area temperature. The results of the research work were showed as exemplary "time" charts, box-plot charts and a summary table, which additionally included an error analysis of the measurement method. On the basis of the tests and measurements performed, it can be concluded that despite the observed chip fragmentation, the obtained temperatures can be defined as the so-called safe milling areas. During the machining tests, the risk of chip ignition during machining was not observed, also the characteristic melting points, which clearly indicates the safety of the milling process of these alloys. It has been observed that with the increase of vc and fz, there was no increase in the maximum temperature of the chip in the cutting area. This situation only occurs when increasing ap.
Źródło:
Advances in Science and Technology. Research Journal; 2022, 16, 2; 109--119
2299-8624
Pojawia się w:
Advances in Science and Technology. Research Journal
Dostawca treści:
Biblioteka Nauki
Artykuł
    Wyświetlanie 1-1 z 1

    Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies