Informacja

Drogi użytkowniku, aplikacja do prawidłowego działania wymaga obsługi JavaScript. Proszę włącz obsługę JavaScript w Twojej przeglądarce.

Wyszukujesz frazę "semi-trailer" wg kryterium: Temat


Wyświetlanie 1-2 z 2
Tytuł:
An assessment of trailer suspension dynamic behavior via vibration measurements
Autorzy:
Hunicz, J.
Koszałka, G.
Golec, M.
Taratuta, L.
Powiązania:
https://bibliotekanauki.pl/articles/241829.pdf
Data publikacji:
2012
Wydawca:
Instytut Techniczny Wojsk Lotniczych
Tematy:
road transport
exceptional transport
semi-trailer
vibration measurements
suspension dynamics
Opis:
A dynamic response of a semi-trailer suspension to a real road profile under two different loads was investigated in this study. The trailer was a low loader for transporting heavy and large loads which configuration could be adjusted to the current needs. During the described investigation the vehicle was composed of: detachable gooseneck, maximally extended low bed and 5 hydraulically steered axles comprised 2-axle and 3-axle assemblies. The experiments were performed for unloaded and loaded with 60 tons trailer, that was equal to maximum trailer pay load. Acceleration measurements at unsprung and sprung parts of the vehicle were applied. As a test surface a railway track crossing was chosen. Acceleration time series were analysed by the means of power spectral density. The isolation of free vibration and forced vibration frequencies and effectiveness of suspension damping over wide frequency range was done. Two characteristic signal bands were identified. In the frequency range up to 10 Hz vehicle vibration energy decreased for the load increase for both, sprung and unsprung parts. In contrast, in the range between 10 and 25 Hz at higher load increase of vibration energy was noticed, however only at unsprung mass. Data analysis revealed complexity of vehicle vertical acceleration as a response to the road profile. Nevertheless, it allowed for estimation of the trailer dynamic loads under real road conditions.
Źródło:
Journal of KONES; 2012, 19, 4; 333-338
1231-4005
2354-0133
Pojawia się w:
Journal of KONES
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Design of a frame to a semi low-loader
Autorzy:
Koszałka, G.
Dębski, H.
Dziurka, M.
Kaczor, M.
Powiązania:
https://bibliotekanauki.pl/articles/242123.pdf
Data publikacji:
2011
Wydawca:
Instytut Techniczny Wojsk Lotniczych
Tematy:
FEM
central beam
supporting structure
extendable semi-trailer
heavy transport
Opis:
The paper presents the process of design of a frame for a semi low loader for the transportation of oversize loads, especially wheeled and tracked machines. After considering different solutions of a frame, a central beam was chosen and an initial design was developed. The initial model of the frame was analyzed with the use of FEM and was then modified. Two final versions of the frame were prepared. One of them was used in a 4 axle trailer with a load deck that can be extended in length and width to carry oversize and heavy loads. An important advantage of the trailer is its versatility and the fact that in a non-extended state it meets the regulations for standard trailers and can carry loads without a special permission. The paper focuses on the application of FEM analysis in the design of the part of the beam where highest stresses were located. A design solution for a ladder frame, a schematic image of a box-type central beam, a design solution for rear ramps, geometrical models of semitrailer frame with boundary conditions, stress distributions in a non-extended and extended frame model, a section of the rear part of the frame with sliding plates visible and a pin guide bar for blocking frame extension, stress distribution in the front part of the frame, single and double supporting rib, side wall supporting plate and stress distribution after the use of plates and one supporting rib, stress distribution after the employment of plates and two supporting ribs, stress distribution in the alternative gooseneck design, main dimensions of the semitrailer, extended semitrailer are presented in the paper.
Źródło:
Journal of KONES; 2011, 18, 2; 215-223
1231-4005
2354-0133
Pojawia się w:
Journal of KONES
Dostawca treści:
Biblioteka Nauki
Artykuł
    Wyświetlanie 1-2 z 2

    Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies