Autor: Nguyen, J.M.T. - Katalog OPAC zbiorów

Skocz do pozycji: 1.

Tytuł:: Formation of Different Cu Nanopowders and Stability of Cu Fluids Produced by Electrical Explosion of Wire in Liquid
Autorzy:: Nguyen, M.-T.
Kim, J.-H.
Kim, J.-C.
Powiązania:: https://bibliotekanauki.pl/articles/355217.pdf
Data publikacji:: 2018
Wydawca:: Polska Akademia Nauk. Czytelnia Czasopism PAN
Tematy:: Cu nanopowder
Cu nanofluids
electrical explosion of wire
stability of nanofluids
Opis:: In this study, copper nanoparticles and nanofluids were synthesized by electrical explosion of wire (EEW) in liquid media such as water, ethanol, and acetone. The effect of the different conditions on the properties of the as-synthesized Cu powders and nanofluids were investigated. X-ray diffraction (XRD) analysis was employed to measure the phase of the as-synthesized powder. Only pure Cu phase appeared in case of acetone condition, but CuO and CuO2 phases could be observed in the others. The EEWed particle size was broadened from under 50 to 100 nm. The results showed that acetone was the best condition for achieving smaller particles, preventing the oxidation of the Cu particles and good stability of the nanofluids.
Źródło:: Archives of Metallurgy and Materials; 2018, 63, 3; 1453-1457
1733-3490
Pojawia się w:: Archives of Metallurgy and Materials
Dostawca treści:: Biblioteka Nauki

Artykuł

Skocz do pozycji: 2.

Tytuł:: Sintering and Microstructures of SUS 316L Powder Produced by 3D Printing Process
Autorzy:: Kim, W. J.
Nguyen, H.-H.
Kim, H. Y.
Nguyen, M.-T.
Park, H. S.
Kim, J.-C.
Powiązania:: https://bibliotekanauki.pl/articles/356018.pdf
Data publikacji:: 2017
Wydawca:: Polska Akademia Nauk. Czytelnia Czasopism PAN
Tematy:: stainless steel
3D printing
selective laser sintering
SUS 316L
flake powder
Opis:: Selective laser sintering (SLS) is a type of laminating sintering technique, using CO₂ laser with (metal, polymer, and ceramic) powders. In this result, the flake SUS 316L was used to achieve a high porous product, and compare to spherical type. After SLS, the porosity of flake-type sample with 34% was quite higher than that of the spherical-type one that had only 11%. The surface roughness of the flake SLS sample were also investigated in both inner and surface parts. The results show that the deviation of the roughness of the surface part is about 64.40μm, while that of the internal one was about 117.65μm, which presents the containing of high porosity in the uneven surfaces. With the process using spherical powder, the sample was quite dense, however, some initial particles still remained as a result of less energy received at the beneath of the processing layer.
Źródło:: Archives of Metallurgy and Materials; 2017, 62, 2B; 1215-1218
1733-3490
Pojawia się w:: Archives of Metallurgy and Materials
Dostawca treści:: Biblioteka Nauki

Artykuł

Informacja