Informacja

Drogi użytkowniku, aplikacja do prawidłowego działania wymaga obsługi JavaScript. Proszę włącz obsługę JavaScript w Twojej przeglądarce.

Wyszukujesz frazę "Hort, N." wg kryterium: Autor


Wyświetlanie 1-2 z 2
Tytuł:
Metallurgical Characterization of Hot Tearing Curves Recorded during Solidification of Magnesium Alloys
Autorzy:
Huang, Y.
Wang, Z.
Srinivasan, A.
Kainer, K.
Hort, N.
Powiązania:
https://bibliotekanauki.pl/articles/1418495.pdf
Data publikacji:
2012-09
Wydawca:
Polska Akademia Nauk. Instytut Fizyki PAN
Tematy:
64.70.D-
62.20.mt
61.25.Mv
61.66.Dk
61.72.Mm
Opis:
This work investigates the hot tearing behavior of Mg-Al and Mg-Zn alloys quantitatively based on the measurement of contraction force using an experimental setup which was developed at MagIC. An emphasis is given on the analysis of typical hot tearing curves to understand the corresponding metallurgical phenomena shown by these curves. The recorded hot tearing curves, i.e. the contraction force vs. temperature or time, contain valuable metallurgical information. They give not only the precise temperature at which the hot tearing initiates, but also depict information about the propagation of hot cracks. Combined with thermodynamic calculations, the critical solid fraction corresponding to the occurrence of hot tearing can be calculated. Further microstructural observations were performed. Several phenomena such as the crack propagation and refilling of cracks, which influence the slope of hot tearing curves, are also discussed.
Źródło:
Acta Physica Polonica A; 2012, 122, 3; 497-500
0587-4246
1898-794X
Pojawia się w:
Acta Physica Polonica A
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
In Situ Investigation of Microstructure Evolution during Solidification of Mg10CaxGd (x=5, 10, 20) Alloys
Autorzy:
Mendis, C.
Tolnai, D.
Stark, A.
Schell, N.
Kainer, K.
Hort, N.
Powiązania:
https://bibliotekanauki.pl/articles/1402097.pdf
Data publikacji:
2015-10
Wydawca:
Polska Akademia Nauk. Instytut Fizyki PAN
Tematy:
81.05.Bx
81.30.Fb
Opis:
Mg-Ca-Gd based alloys are investigated as a potential alloy for degradable biomaterials with some promising results. In this investigation the Mg10CaxGd (x=5, 10, 20) were investigated with synchrotron radiation X-ray diffraction during solidification to follow the phase evolution at two different cooling rates at 5 and $50 K \text{min}^{-1}$. All three alloys show formation of α -Mg followed by Mg₂Ca phase, while only Mg10Ca20Gd alloy contained Mg₅Gd phase during solidification. During cooling α -Mg was first observed between 628 and 632°C at a cooling rate of $5 K \text{min}^{-1}$ while this decreased to 620-628°C with the increase in cooling rate to $50 K \text{min}^{-1}$. The change in cooling rate from $5$ to $50 K \text{min}^{-1}$ did not change the types of intermetallic phases observed but resulted in suppressing temperatures at which the intermetallic phases were first detected.
Źródło:
Acta Physica Polonica A; 2015, 128, 4; 606-610
0587-4246
1898-794X
Pojawia się w:
Acta Physica Polonica A
Dostawca treści:
Biblioteka Nauki
Artykuł
    Wyświetlanie 1-2 z 2

    Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies