Informacja

Drogi użytkowniku, aplikacja do prawidłowego działania wymaga obsługi JavaScript. Proszę włącz obsługę JavaScript w Twojej przeglądarce.

Wyszukujesz frazę "cell flotation" wg kryterium: Temat


Wyświetlanie 1-2 z 2
Tytuł:
Investigating the effect of lip froth washing on coal yield during flotation of a high ash South African coal
Autorzy:
du Plessis, Cherryl
Sibanda, Vusumuzi
Dworzanowski, Marek
Danha, Gwiranai
Mamvura, Tirivaviri A.
Powiązania:
https://bibliotekanauki.pl/articles/2146887.pdf
Data publikacji:
2021
Wydawca:
Politechnika Wrocławska. Oficyna Wydawnicza Politechniki Wrocławskiej
Tematy:
flotation
mechanical flotation cell
flotation reagents
lip froth washing
coal yield
primary wash cells
secondary wash cells
Opis:
An investigation was conducted to evaluate the effect of lip washing on coal flotation at Anglo American’s Goedehoop South (GHS) fine coal plant in South Africa. In the test-work, performance of cells with lip washing system were compared with baseline cells without lip washing in terms of coal yield and coal quality. Yields observed with lip washing were significantly higher than those of baseline cells. Improvements of up to 15% were recorded. The product obtained at low flotation reagent dosages (1.30–1.45 kg/t) on lip wash cells had ~16.85% ash content against ~17.65% with baseline cells, suggesting that higher yields could be achieved at superior qualities to those achieved with baseline cells. At higher reagent dosages (1.60–1.75 kg/t), coal yields further improved but quality reduced on lip wash cells. Calorific Values (CV) of coal products obtained by lip washing and baseline flotation were similar. When different coal particle size fractions were floated separately, the yield increased as particle size increased from 75 to 300 μm and then decreased from 300 to 500 μm for both baseline and lip washing flotation. Lip washing caused a marked increase in the yield for finer particles (< 300 μm) with optimum size class of between 212 – 300 μm. In addition, a much bigger increase in the yield was achievable with lip washing of lower quality coal. The ash content after lip washing of poor-quality coal were also comparable to the ash content after lip washing of good quality coal.
Źródło:
Physicochemical Problems of Mineral Processing; 2021, 57, 6; 169--181
1643-1049
2084-4735
Pojawia się w:
Physicochemical Problems of Mineral Processing
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Determination of bubble size distribution in a laboratory mechanical flotation cell by a laser diffraction technique
Autorzy:
Mazahernasab, R.
Ahmadi, R.
Powiązania:
https://bibliotekanauki.pl/articles/110401.pdf
Data publikacji:
2016
Wydawca:
Politechnika Wrocławska. Oficyna Wydawnicza Politechniki Wrocławskiej
Tematy:
bubble size distribution
mechanical flotation cell
laser diffraction technique (LDT)
Image Analysis Technique (IAT)
effective parameters
Opis:
In this study, a laser diffraction technique (LDT) was used to measure size distribution of bubbles generated in a two-phase system in a laboratory mechanical flotation cell. In LDT, a laser light beam passed through the bubbles inside the measurement cell and the scattered light was recorded by detectors. In order to show the effectiveness of LDT, an image analysis technique (IAT) was applied in parallel to measure the size of bubbles. To determine the bubble size by IAT, around 200 images were taken in each test. In addition, the important operating parameters of the mechanical flotation cell affecting the bubble size distribution, including the impeller speed, aeration rate and frother concentration, were investigated. The response parameter in this study was Db(50) which represent the size of bubble at which there is 50% of the distribution. The results of this study showed that the LDT and IAT techniques were in a good agreement when Db(50) was in the range of -800+400 μm and there was a discrepancy for Db(50) in the range of -400+100 μm. Furthermore, Db(50) decreased from 727 to 284 μm when impeller speed increased from 700 to 1200 rpm. Additionally, an increase in the aeration rate from 1 dm3/min to 2.5 dm3/min led to a rise in Db(50) from 418 to 456 μm. Finally, increasing the frother concentration from 10 to 60 ppm reduced the Db(50) from 704 to 387 μm.
Źródło:
Physicochemical Problems of Mineral Processing; 2016, 52, 2; 690-702
1643-1049
2084-4735
Pojawia się w:
Physicochemical Problems of Mineral Processing
Dostawca treści:
Biblioteka Nauki
Artykuł
    Wyświetlanie 1-2 z 2

    Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies