Informacja

Drogi użytkowniku, aplikacja do prawidłowego działania wymaga obsługi JavaScript. Proszę włącz obsługę JavaScript w Twojej przeglądarce.

Wyszukujesz frazę "combustion gases" wg kryterium: Wszystkie pola


Wyświetlanie 1-4 z 4
Tytuł:
Hydrogen rich gases combustion in the IC engine
Autorzy:
Szwaja, S.
Powiązania:
https://bibliotekanauki.pl/articles/245372.pdf
Data publikacji:
2009
Wydawca:
Instytut Techniczny Wojsk Lotniczych
Tematy:
syngas
coke gas
hydrogen
combustion
Opis:
Experimental results of combusting three different syngases in an internal combustion (IC) spark ignition engine are presented in this paper. The syngases used for tests varied each from the other with hydrogen content, which was of 10,15 and 60%. Other combustible gases as CO and CH4 were also changed. Thus, the lower heating value of the syngases was of 2.7, 4.6 and 17.2 MJ/nm3, respectively. Combustion tests were performed at stoichiometric ratio of syngas-air mixture, with variable spark timing and constant compression ratio of 10. On the basis of in-cylinder combustion pressure histories the indicated mean effective pressure (IMEP) was computed and presented versus spark timing and vs location of the middle combustion phase expressed by the 50% of mass fraction burned (MFB). Additionally, the 0-10% MFB and 10-90% MFB were also determined. Furthermore, the paper contains theoretical determination of the three fuel quantities, which can affect combustion duration and heat release rate during burning the syngases in the IC engine. They are as follows: laminar flame speed, ignition delay and adiabatic flame temperature. Final results does not show satisfactory correlation between LFS computed at NTP and real combustion phasing. Furthermore, both long combustion duration and long 0-10% MFB leading to unstable combustion were observed for the syngas with the lowest LHV of 2.7 MJ/nm3.
Źródło:
Journal of KONES; 2009, 16, 4; 447-454
1231-4005
2354-0133
Pojawia się w:
Journal of KONES
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Numerical studies on the influence of air staging on the temperature of flue gas and emission of gases in the combustion chamber of OP 230 boiler
Autorzy:
Hernik, B.
Jagodzińska, K.
Matuszek, D.
Powiązania:
https://bibliotekanauki.pl/articles/185572.pdf
Data publikacji:
2018
Wydawca:
Polska Akademia Nauk. Czytelnia Czasopism PAN
Tematy:
combustion
CFD
emission
boiler
NOx
spalanie
emisja
bojler
Opis:
The primary methods of reducing nitrogen oxides, despite the development of more advanced technologies, will continue to be the basis for NOx reduction. This paper presents the results of multivariate numerical studies on the impact of air staging on the flue gas temperature and composition, as well as on NOx emissions in a OP 230 boiler furnace. A numerical model of the furnace and the platen superheater was validated based on measurements using a 0-dimensional model of the boiler. Numerical simulations were performed using the ANSYS Workbench package. It is shown that changes in the distribution of air to OFA nozzles, the angle of the air outflow from the nozzles and the nozzle location involve a change in the flue gas temperature and in the volume of NOx and CO emissions at the furnace outlet.
Źródło:
Chemical and Process Engineering; 2018, 39, 1; 59--74
0208-6425
2300-1925
Pojawia się w:
Chemical and Process Engineering
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Stężenia podstawowych zanieczyszczeń w gazach spalinowych, powstających w procesie spalania granulatu ślazowca i drewna w kotle małej mocy.
The concentration of elementary pollution in exhaust gases during combustion of pellets, made of virginia and wood, in low-power boiler
Autorzy:
Janicki, M
Powiązania:
https://bibliotekanauki.pl/articles/357625.pdf
Data publikacji:
2014
Wydawca:
Politechnika Śląska
Tematy:
combustion
virginia mallow
wood
pellet burner
physical-chemical analysis
fuel analysis
emission
spalanie
ślazowiec pensylwański
drewno
palnik na pelety
analiza fizykochemiczna
analiza paliw
emisja
Opis:
Biomass is considered as difficult to obtain and to use as a fuel, due to its non-homogeneous physical properties and chemical composition. One of the methods of limiting those difficulties is granulation. Granulation is a pre-preparation process that involves stabilization of technical parameters of the material by increasing the bulk density and limiting the moisture content and therefore raising its calorific value. Virginia mallow and wood pellets were the two kinds of biomass fuel that were selected to perform this study. In order to conduct the concentration of pollutants analysis, a series of combustion tests on these materials was carried out under various conditions in standard and modified fire chamber. In an automatic, low-power boiler with horizontal pellet burner the standard design is a steel circular furnace surrounding the fire chamber. Modification which ensures that the “hot chamber” conditions are met is the use of a ceramic lagting. The lagting has catalytic properties and it reduces the direct heat transfer by limiting access of the flame to the water jacket.
Biomasa, ze względu na swoją niejednorodność w składzie fizycznym jak i chemicznym, jest uważana za paliwo uciążliwe zarówno na etapie pozyskania, jak i termicznego jej wykorzystania. Jednym ze sposobów na ograniczenie niejednorodności jest jej wstępna obróbka polegająca na stabilizacji parametrów technicznych, czyli paletyzacja. Zabieg ten ma na calu zwiększenie gęstości nasypowej materiału palnego, ograniczenie w nim zawartości wilgoci i podwyższenie wartości opałowej paliwa. Do badań wytypowano dwa rodzaje biomas w formie peletu: ślazowiec oraz drewno. W celu wykonania analizy stężeń zanieczyszczeń powietrza podczas spalania omawianych paliw, wykonano testy na mieszance paliw a także podjęto próby spalania w różnych warunkach: na komorze standardowego (seryjnego) wyposażenia kotła, oraz modyfikowanego. W automatycznym kotle małej mocy, z poziomym palnikiem na pelet, standardową konstrukcją jest stalowy płomienicowy wymiennik ciepła, otaczający komorę spalania. Modyfikacja polegała na zastosowaniu otuliny ceramicznej, ograniczającej bezpośrednią wymianę ciepła w komorze a jednocześnie charakteryzującej się właściwościami katalitycznymi.
Źródło:
Archiwum Gospodarki Odpadami i Ochrony Środowiska; 2014, 16, 4; 103-112
1733-4381
Pojawia się w:
Archiwum Gospodarki Odpadami i Ochrony Środowiska
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
The Influence of Olive Oil Waste as a Biofuel on the Exhaust Gases of the Internal Combustion Engine
Autorzy:
Al-Aseebee, Munaf D. F.
Naje, Ahmed Samir
Powiązania:
https://bibliotekanauki.pl/articles/24201727.pdf
Data publikacji:
2023
Wydawca:
Polskie Towarzystwo Inżynierii Ekologicznej
Tematy:
olive oil
waste
biofuel
combustion
engine
Opis:
Future options for addressing the depletion of fossil fuels and reducing pollution from internal combustion engines may include biofuel as an alternative fuel. This study aims to experimentally and statistically assess the effect of using diesel-biofuel blends on the emissions of a single-cylinder direct-injection engine. Using recycled olive oil, a chemical Tran’s esterification process was used to create biofuel. The experimental results were contrasted with those of a one-dimensional engine model for exhaust emissions and torque, which showed high agreement between test and numerical data. In order to comprehend the factors that affect the engine’s reaction to variations in fuel composition, the thermodynamic characteristics of the engine for various blends were also supplied. According to the investigation, a mixture with 20% of the volume fraction of oleic acid methyl ester olive-based biofuel and 80% of the volume fraction of pure diesel can be an effective fuel alternative for cleaner exhaust emissions while offering almost the same performance.
Źródło:
Journal of Ecological Engineering; 2023, 24, 5; 322--328
2299-8993
Pojawia się w:
Journal of Ecological Engineering
Dostawca treści:
Biblioteka Nauki
Artykuł
    Wyświetlanie 1-4 z 4

    Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies