- Tytuł:
- The analysis of influence on friction factor at constant force for marine pump shafts after finishing treatment
- Autorzy:
-
Labuda, W.
Charchalis, A. - Powiązania:
- https://bibliotekanauki.pl/articles/243518.pdf
- Data publikacji:
- 2013
- Wydawca:
- Instytut Techniczny Wojsk Lotniczych
- Tematy:
-
plastic tooling
burnishing
stainless steel
angular momentum pump
friction factor - Opis:
- Angular momentum pumps are very often used in cooling circuits of medium and high power engines, power plant boilers as well as bilge, ballast and fire installations. Such an extensive use of angular momentum pumps on board is connected with their numerous advantages. However during operation the wear of marine hull, the rotor and shaft seals takes place. The research attempts to increase the service life of shafts. The article presents the research results referring to the analysis of the influence of finish treatment (finishing turning, grinding, burnishing) on the friction factor of steel applied to marine pump shafts. The research was performed on a roller 39 mm in diameter made of 304L stainless steel. The finish tooling of pump shaft pins was carry out on a universal centre lathe. The finish turning process was carried out by means of a WNMG WF 080408 Sandvik Coromant cutting tool with replaceable inserts. The grinding process was performed by grinding attachment for lathes. The 1-80x10x32-99C 80-N V grinding wheel was used for the process. The process of burnishing was done by SRMD single roll burnishing tool by Yamato. The burnishing process was carried out at the following technological parameters: burnishing force 1.1 kN, burnishing speed 35 m/min, feed 0.13 mm/rev. In addition, the influence of the number of burnishing tool passes on the friction factor was determined. The paper aimed at defining the influence of burnishing on service conditions by: testing electrochemical corrosion, friction wear and contact fatigue. The work presented the research results of friction factor tests of the samples after finish turning, grinding and burnishing. In addition, the influence of the burnisher passes number on the friction factor was determined. The experiment was performed on block – roll tester machine.
- Źródło:
-
Journal of KONES; 2013, 20, 2; 245-251
1231-4005
2354-0133 - Pojawia się w:
- Journal of KONES
- Dostawca treści:
- Biblioteka Nauki
Artykuł