Informacja

Drogi użytkowniku, aplikacja do prawidłowego działania wymaga obsługi JavaScript. Proszę włącz obsługę JavaScript w Twojej przeglądarce.

Wyszukujesz frazę "bearing systems" wg kryterium: Temat


Wyświetlanie 1-2 z 2
Tytuł:
Influence of local bush wear on properties of water lubricated marine stern tube bearings
Autorzy:
Litwin, W.
Powiązania:
https://bibliotekanauki.pl/articles/259292.pdf
Data publikacji:
2011
Wydawca:
Politechnika Gdańska. Wydział Inżynierii Mechanicznej i Okrętownictwa
Tematy:
water-lubricated bearing
bearing systems
propeller shaft bearing systems
Opis:
In recent years more and more frequently can be met ships in which propeller shaft water-lubricated polymer bearings have been applied. It results from their simplicity and associated relatively low initial and operational cost as compared with the complex classical sealed system based on oil-lubricated bearings. It is worth mentioning that the water-lubricated bearings are also environmentally friendly as no risk of pollution with lubricating oil used in classical systems, is involved. Design procedure of bearings in question based on materials available from their producers is relatively simple. However the calculating of such bearings creates many problems. For calculating the hydrodynamic lubricating theory is as a rule used and elastic bush flexibility taken into account. In the case of greater loads when lubricating film is very thin to achieve a proper solution is very difficult. For this reason is proposed a novel method in which bush local wear effect can be accounted for. Such phenomenon has been observed during experimental tests of heavy-loaded water-lubricated slide bearings. With the use of the applied calculation algorithm bush local wear close to its edges can be taken into account, and - in consequence - a greater bearing capacity can be achieved.
Źródło:
Polish Maritime Research; 2011, 1; 32-36
1233-2585
Pojawia się w:
Polish Maritime Research
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
The Dynamic Performance Analysis of the Foil Bearing Struture
Autorzy:
Żywica, G.
Powiązania:
https://bibliotekanauki.pl/articles/386913.pdf
Data publikacji:
2013
Wydawca:
Politechnika Białostocka. Oficyna Wydawnicza Politechniki Białostockiej
Tematy:
łożysko foliowe
systemy łożyskowania
mikroturbiny
wirnik
foil bearing
bearing systems
micro-turbines
Opis:
Foil bearings are a variety of slide bearings in which an additional set of foils is applied between journal and bush, in order to improve the selected static and dynamic properties. Engineers and researchers from all over the world investigate bearings of this type since many years - both from numerical as well as experimental point of view. Due to the complexity of construction, the reliable simulation models are all the time being searched for. This paper discusses the important stages of elaboration of the structural supporting layer numerical model of the foil bearing as well as results of verification tests. The main goal of the conducted study was assessment of reliability of the elaborated numerical model, in scope of dynamic properties. In the near future it will be used for elaboration of the numerical model of the entire foil bearing, which will take into account also phenomena in fluid-film layer. Those models will be used together to describe bearing system in operation.
Źródło:
Acta Mechanica et Automatica; 2013, 7, 1; 58-62
1898-4088
2300-5319
Pojawia się w:
Acta Mechanica et Automatica
Dostawca treści:
Biblioteka Nauki
Artykuł
    Wyświetlanie 1-2 z 2

    Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies