Informacja

Drogi użytkowniku, aplikacja do prawidłowego działania wymaga obsługi JavaScript. Proszę włącz obsługę JavaScript w Twojej przeglądarce.

Wyszukujesz frazę "Ansys Fluent" wg kryterium: Temat


Wyświetlanie 1-5 z 5
Tytuł:
Gas outflow from an underground site – numerical simulations into baric tendency and airflow rate relationship
Emisja gazów z górotworu – symulacje numeryczne wpływu tendencji barycznej na intensywność przepływu gazów
Autorzy:
Wrona, P.
Król, A.
Król, M.
Powiązania:
https://bibliotekanauki.pl/articles/219607.pdf
Data publikacji:
2018
Wydawca:
Polska Akademia Nauk. Czytelnia Czasopism PAN
Tematy:
symulacja CFD
emisja CO2
ANSYS Fluent
oddziaływanie na środowisko
zagrożenie gazowe
CFD simulation
CO2 leak
Ansys Fluent
environmental impact
gas hazard
Opis:
Gas emissions from underground sites to the atmosphere depend on many factors. Pressure drops are considered to be the most important. However, emissions can also be observed during the initial phase of the pressure rise, following a previous drop in pressure. On the other hand, gas emissions may not be detected when the pressure drops, especially when a previous pressure rise has taken place. The aim of the research was to determine the role of variations in baric tendency on airflow rate and its direction. To solve this problem a numerical model was built utilizing the Ansys Fluent software package. Subsequently, three scenarios of baric tendency variations were tested: a) rise – drop, b) drop – drop, c) drop – rise. The results showed inert behavior of gases. Under scenario (c), 1 hour after the change in tendency gases still were flowing out to the atmosphere. Considering scenario (a), it was proved that even during a pressure drop gas emissions do not take place, which can be crucial for further determination of the gas hazard at the surface or for assessment of the rate of gas emissions from a particular gas emitter. Scenario (b) merely gave an overview of the process and was mainly used for validation purposes. It gave a maximal CO2 concentration of 2.18%vol (comparable to measurements) and a CO2 mass flow rate 0.15kg/s. Taking into account greenhouse gas emissions this amounted to 514 kg CO2/h.
Emisja gazów z górotworu do atmosfery zależy od wielu czynników, z których jako najważniejszy uznawane są spadki ciśnienia atmosferycznego. Jednakże podczas prowadzonych badań wypływ gazów został także odnotowany podczas początkowego okresu zwyżki barycznej, poprzedzonego zniżką. Wystąpiło także zjawisko braku wypływu gazów mimo występującej zniżki barycznej, w szczególności po okresie wzrostu ciśnienia. Dlatego celem przeprowadzonych badań było określenie wpływu zmian ciśnienia atmosferycznego (rodzaju tendencji barycznej) na natężenie przepływu gazów pomiędzy górotworem a atmosferą oraz wyznaczenie jego kierunku. Do badań stworzono model numeryczny zjawiska w programie Ansys Fluent. Założono trzy warianty zmian ciśnienia: a) zwyżka – zniżka, b) zniżka – zniżka, c) zniżka – zwyżka. Otrzymane wyniki potwierdziły występującą bezwładność badanego procesu. W przypadku scenariusza (c), 1 gazy wypływały do atmosfery przez okres godziny po zmianie tendencji barycznej ze zniżki na zwyżkę. Rozpatrując scenariusz (a), dowiedziono, że emisja gazów może nie wystąpić mimo zachodzącej zniżki ciśnienia atmosferycznego. Może to mieć kluczowe znaczenie przy określaniu zagrożenia gazowego na powierzchni terenu lub wyznaczaniu intensywności emisji gazów z górotworu. Scenariusz (b) był scenariuszem porównawczym i służył do walidacji modelu. Dla tego scenariusza otrzymano maksymalne stężenie CO2 wynoszące 2.18%vol (wartość porównywalna ze stwierdzoną podczas pomiarów) oraz natężenie emisji CO2 równe 0.15kg/s. W przeliczeniu na emisję godzinną jest to 514kg CO2/h. Wartość ta ma znaczenie pod kątem emisji gazów cieplarnianych do atmosfery.
Źródło:
Archives of Mining Sciences; 2018, 63, 2; 251-268
0860-7001
Pojawia się w:
Archives of Mining Sciences
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Numerical Analysis of The Effect of Hydrodynamics and Operating Conditions on Biodiesel Synthesis in a Rotor-Stator Spinning Disk Reactor
Autorzy:
Wen, Z.
Petera, J.
Powiązania:
https://bibliotekanauki.pl/articles/184848.pdf
Data publikacji:
2017
Wydawca:
Polska Akademia Nauk. Czytelnia Czasopism PAN
Tematy:
biodiesel synthesis
ANSYS Fluent
rotor-stator reactor
backflow
operating conditions
biodiesel
Opis:
A rotor-stator spinning disk reactor for intensified biodiesel synthesis is described and numerically simulated in the present research. The reactor consists of two flat disks, located coaxially and parallel to each other with a gap ranging from 0.1 mm to 0.2 mm between the disks. The upper disk is located on a rotating shaft while the lower disk is stationary. The feed liquids, triglycerides (TG) and methanol are injected into the reactor from centres of rotating disk and stationary disk, respectively. Fluid hydrodynamics in the reactor for synthesis of biodiesel from TG and methanol in the presence of a sodium hydroxide catalyst are simulated, using convection-diffusion-reaction multicomponent transport model with the CFD software ANSYS©Fluent v. 13.0. Effect of operating conditions on TG conversion is particularly investigated. Simulation results indicate that there is occurrence of back flow close to the stator at the outlet zone. Small gap size and fast rotational speed generally help to intensify mixing among reagents, and consequently enhance TG conversion. However, increasing rotational speed of spinning disk leads to more backflow, which decreases TG conversion. Large flow rate of TG at inlet is not recommended as well because of the short mean residence time of reactants inside the reactor.
Źródło:
Chemical and Process Engineering; 2017, 38, 2; 265-281
0208-6425
2300-1925
Pojawia się w:
Chemical and Process Engineering
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Model study of tundish steel intermixing and operational verification
Modelowe studium mieszania stali w kadzi pośredniej i weryfikacja wyników w warunkach przemysłowych
Autorzy:
Michalek, K.
Gryc, K.
Tkadleckova, M.
Bocek, D.
Powiązania:
https://bibliotekanauki.pl/articles/354610.pdf
Data publikacji:
2012
Wydawca:
Polska Akademia Nauk. Czytelnia Czasopism PAN
Tematy:
stal
mieszanie
modelowanie
CFD
RTD
steel
tundish
intermixing zone
modelling
ANSYS Fluent
Opis:
The aim of this paper will be to present new knowledge and experience from numerical and physical modelling of metallurgical processes at the Department of Metallurgy, VSB - Technical University of Ostrava in Czech Republic and to explain especially the principle of tundish process simulations. The numerical modelling was realized by the CFD program FLUENT. The paper describes the pre-processing, processing and post-processing phases of numerical modelling. The physical modelling of the steel flow verification is based on a monitoring of the time dependency of concentration changes during experiments for individual tundish outlets. There exist two basic methods of KCl concentration change utilization in this "water" physical tundish modelling methodology. The utilization of mentioned methods are discussed and possible future developments are outlined for research of tundish steel intermixing.
Celem artykułu jest przedstawienie wyników i doświadczeń z numerycznego i fizycznego modelowania procesów metalurgicznych w Zakładzie Metalurgii, VSB - Uniwersytet Techniczny w Ostrawie (Republika Czeska) i wyjaśnienie zasady symulacji procesów mieszania stali w kadzi pośredniej. Program CFD FLUENT posłużył do modelowania numerycznego. W artykule opisano pre-processing, processing i post-processing modelowania numerycznego. Weryfikację modelowania fizycznego przepływu stali dokonano w oparciu o eksperymenty, w których monitorowano zmianę stężenia w czasie dla poszczególnych stref kadzi. Istnieją dwie podstawowe metody wykorzystania zmian stężenia KCl w wodzie. Omówiono wykorzystanie wymienionych metod i możliwości przyszłego rozwoju badań mieszania stali w kadzi pośredniej.
Źródło:
Archives of Metallurgy and Materials; 2012, 57, 1; 291-296
1733-3490
Pojawia się w:
Archives of Metallurgy and Materials
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
CFD Numerical Simulation of Biodiesel Synthesis in a Spinning Disc Reactor
Autorzy:
Wen, Z.
Petera, J.
Powiązania:
https://bibliotekanauki.pl/articles/184923.pdf
Data publikacji:
2015
Wydawca:
Polska Akademia Nauk. Czytelnia Czasopism PAN
Tematy:
spinning disc
biodiesel synthesis
ANSYS Fluent
numerical simulation
TG conversion
symulacja numeryczna
konwersja TG
Opis:
In this paper a two-disc spinning disc reactor for intensified biodiesel synthesis is described and numerically simulated. The reactor consists of two flat discs, located coaxially and parallel to each other with a gap of 0.2 mm between the discs. The upper disc is located on a rotating shaft while the lower disc is stationary. The feed liquids, triglycerides (TG) and methanol are introduced coaxially along the centre line of rotating disc and stationary disc. Fluid hydrodynamics in the reactor for synthesis of biodiesel from TG and methanol in the presence of a sodium hydroxide catalyst are simulated, using convection-diffusion-reaction species transport model by the CFD software ANSYS©Fluent v. 13.0. The effect of the upper disc’s spinning speed is evaluated. The results show that the rotational speed increase causes an increase of TG conversion despite the fact that the residence time decreases. Compared to data obtained from adequate experiments, the model shows a satisfactory agreement.
Źródło:
Chemical and Process Engineering; 2015, 36, 1; 21-37
0208-6425
2300-1925
Pojawia się w:
Chemical and Process Engineering
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Experimental and numerical analyses of airflow around two cylinders angled to the direction of wind
Autorzy:
Padewska-Jurczak, Agnieszka
Szczepaniak, Piotr
Walentyński, Ryszard
Powiązania:
https://bibliotekanauki.pl/articles/2204499.pdf
Data publikacji:
2023
Wydawca:
Polska Akademia Nauk. Czytelnia Czasopism PAN
Tematy:
wind action
CFD
computational fluid dynamics
FVM
finite volume method
ANSYS Fluent
wind tunnel test
water slide
działanie wiatru
obliczeniowa dynamika płynów
metoda objętości skończonych
testy w tunelu aerodynamicznym
zjeżdżalnia wodna
Opis:
The analyses aim to determine aerodynamic force coefficients in the case of airflow around two smooth or rough cylinders positioned at different angles to the direction of wind velocity. Such systems, for instance, may be part of a tubular water slide. The results were compared with the values of the interference coefficient of the cylinders arranged in a row included in Eurocode EN 1991 part 4. The aerodynamic forces of the cylinder systems were determined on the basis of experimental tests conducted in a wind tunnel. To verify the above results, CFD (computational fluid dynamics) simulations were prepared. An important observation is that for the angle of yaw β = 0◦, the negative component of the lift force (lateral) fy is shown, while for the other cases, the situation is opposite and the lateral force points outside the gap (upward). The second is that the results of aerodynamic drag for rough cylinders arranged in a row and calculated according to EN 1991 part 4 may be underestimated. The flow around the pair of smooth cylinders is quite different from that of the rough ones, because during the experiment the first falls into the critical flow regime, while the second has supercritical characteristics.
Źródło:
Bulletin of the Polish Academy of Sciences. Technical Sciences; 2023, 71, 1; art. no. e144578
0239-7528
Pojawia się w:
Bulletin of the Polish Academy of Sciences. Technical Sciences
Dostawca treści:
Biblioteka Nauki
Artykuł
    Wyświetlanie 1-5 z 5

    Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies