Informacja

Drogi użytkowniku, aplikacja do prawidłowego działania wymaga obsługi JavaScript. Proszę włącz obsługę JavaScript w Twojej przeglądarce.

Wyszukujesz frazę "Su, S." wg kryterium: Autor


Wyświetlanie 1-5 z 5
Tytuł:
Matched-field Source Localization with a Mobile Short Horizontal Linear Array in Offshore Shallow Water
Autorzy:
Zhao, D.
Huang, Z.
Su, S.
Li, T.
Powiązania:
https://bibliotekanauki.pl/articles/177986.pdf
Data publikacji:
2013
Wydawca:
Polska Akademia Nauk. Czytelnia Czasopism PAN
Tematy:
passive source localization
matched-field processing
inter-position processing
short horizontal array
shallow water
Opis:
Passive source localization in shallow water has always been an important and challenging problem. Implementing scientific research, surveying, and monitoring using a short, less than ten meter long, horizontal linear array has received considerable attention in the recent years. The short array can be conveniently placed on autonomous underwater vehicles and deployed for adaptive spatial sampling. However, it is usually difficult to obtain a sufficient spatial gain for localizing long-range sources due to its limited physical size. To address this problem, a localization approach is proposed which is based on matched-field processing of the likelihood of the passive source localization in shallow water, as well as inter-position processing for the improved localization performance and the enhanced stability of the estimation process. The ability of the proposed approach is examined through the two-dimensional synthetic test cases which involves ocean environmental mismatch and position errors of the short array. The presented results illustrate the localization performance for various source locations at different signal- to-noise ratios and demonstrate the build up over time of the positional parameters of the estimated source as the short array moves at a low speed along a straight line at a certain depth.
Źródło:
Archives of Acoustics; 2013, 38, 1; 105-113
0137-5075
Pojawia się w:
Archives of Acoustics
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Comparative growth kinetic study of Newcastle disease virus, infectious bursal disease virus and avian influenza virus in chicken embryo fibroblast and DF-1 cell lines
Autorzy:
Anam, S.
Rahman, S.U.
Ali, S.
Saeed, M.
Goyal, S.M.
Powiązania:
https://bibliotekanauki.pl/articles/2087170.pdf
Data publikacji:
2021
Wydawca:
Polska Akademia Nauk. Czytelnia Czasopism PAN
Tematy:
cytopathic effect
titer
growth kinetic
vaccine production
Źródło:
Polish Journal of Veterinary Sciences; 2021, 24, 2; 287-292
1505-1773
Pojawia się w:
Polish Journal of Veterinary Sciences
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Mass transfer analysis of two-phase flow in a suspension of microorganisms
Autorzy:
Mamatha, S.U.
Ramesh, Babu, K.
Durga Prasad, Putta
Raju, C.S.K.
Varma, S.V.K.
Powiązania:
https://bibliotekanauki.pl/articles/240799.pdf
Data publikacji:
2020
Wydawca:
Polska Akademia Nauk. Czytelnia Czasopism PAN
Tematy:
gyrotactic microorganisms
dusty fluid
mass transfer
stretching sheet
bio convection
boundary layer flow
Opis:
The aim of present work is to investigate the mass transfer of steady incompressible hydromagnetic fluid near the stagnation point with deferment of dust particles over a stretching surface. Most researchers tried to improve the mass transfer by inclusion of cross-diffusion or dust particles due to their vast applications in industrial processes, extrusion process, chemical processing, manufacturing of various types of liquid drinks and in various engineering treatments. To encourage the mass transport phenomena in this study we incorporated dust with microorganisms. Conservation of mass, momentum, concentration and density of microorganisms are used in relevant flow equations. The arising system of nonlinear partial differential equations is transformed into nonlinear ordinary differential equations. The numerical solutions are obtained by the Runge-Kutta based shooting technique and the local Sherwood number is computed for various values of the physical governing parameters (Lewis number, Peclet number, Eckert number). An important finding of present work is that larger values of these parameters encourage the mass transfer rate, and the motile organisms density profiles are augmented with the larger values of fluid particle interaction parameter with reference to bioconvection, bioconvection Lewis number, and dust particle concentration parameter..
Źródło:
Archives of Thermodynamics; 2020, 41, 1; 175-192
1231-0956
2083-6023
Pojawia się w:
Archives of Thermodynamics
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Remote pipeline pumping transportation of cemented tailings backfill slurry
Przetłaczanie na znaczne odległości zawiesiny zawierającej odpady poflotacyjne oraz cement rurociągami z wykorzystaniem pomp
Autorzy:
Xiao, S.
Liu, Z.
Jiang, Y.
Li, C.
Sun, C.
Su, L.
Powiązania:
https://bibliotekanauki.pl/articles/219530.pdf
Data publikacji:
2018
Wydawca:
Polska Akademia Nauk. Czytelnia Czasopism PAN
Tematy:
opory przepływu
przetłaczanie
eksperyment z wykorzystaniem linii obiegowej rurociągu
właściwości reologiczne
CFD (Computational Fluid Dynamics)
strong resistance
pipe pumping
pumping looping pipe experiment
rheological characteristic
CFD
Opis:
For most precious metal mines, cemented tailings backfill slurry (CTBS) with different cement-sand ratio and solid concentration are transported into the gobs to keep the stability of the stope and mitigate environmental pollution by mine tailing. However, transporting several kinds of CTBS through the same pipeline will increase the risk of pipe plugging. Therefore, the joint impacts of cement-sand ratio and solid concentration on the rheological characteristics of CTBS need a more in-depth study. Based on the experiments of physical and mechanical parameters of fresh slurry, the loss of pumping pressure while transporting CTBS with different cement-sand ratio, flux and solid mass concentration were measured using pumping looping pipe experiments to investigate the joint impacts of cement-sand ratio and solid concentration on the rheological characteristics of CTBS. Meanwhile, the effect of different stopped pumping time on blockage accident was revealed and discussed by the restarting pumping experiments. Furthermore, Fluent software was applied to calculate the pressure loss and velocity distribution in the pipeline to further analysis experimental results. The overall trends of the simulation results were good agreement with the experiment results. Then, the numerical model of the pipeline in the Sanshandao gold mine was conducted to simulate the characteristics of CTBS pipeline transportation. The results show that the pumping pressure of the delivery pump can meet the transportation requirements when there is no blockage accident. This can provide a theoretical method for the parameters optimizing in the pipeline transportation system.
W większości kopalń metali szlachetnych zawiesina zawierająca odpady poflotacyjne wraz z cementem w różnych proporcjach cementu i piasku oraz o różnym stężeniu części stałych transportowana jest do wyrobisk i zrobów, gdzie wykorzystywana jest następnie do stabilizacji w rejonie przodka, ponadto w ten sposób ogranicza się zanieczyszczenie środowiska odpadami poflotacyjnymi. Jednakże przetłaczanie różnych rodzajów zawiesin w tym samym układzie rurociągu zwiększa ryzyko zaczopowania rur. Zbadanie wpływu proporcji cementu do piasku w zawiesinie oraz stężenia części stałych na charakterystykę reologiczną zawiesiny wydaje się kwestią kluczową. W oparciu o badania eksperymentalne fizycznych i mechanicznych parametrów świeżej zawiesiny, dokonano pomiarów spadku ciśnienia pompowania w trakcie przetłaczania zawiesin o zawartości cementu i pisaku w różnych proporcjach, dla różnych natężeń przepływu i stężeń części stałych w eksperymentach z wykorzystaniem linii obiegowej rurociągu. Celem eksperymentu było określenie łącznego wpływu proporcji cementu do piasku oraz stężenia części stałych na właściwości reologiczne zawiesiny. Ponadto, przeanalizowano w jaki sposób długość przerw w procesie przetłaczania wpływa na zwiększenie ryzyka zatkania rur i przeprowadzono eksperymenty polegające na wznowieniu pracy pomp. Analizę wyników eksperymentów uzupełniono poprzez zastosowanie oprogramowania Fluent do obliczenia spadku ciśnienia w rurociągu oraz rozkładu prędkości. Wykazano, że wyniki symulacji pozostawały w dużej zgodności z wynikami eksperymentów. W kolejnym kroku opracowano model numeryczny rurociągu eksploatowanego w kopalni złota Sanshandao dla potrzeb symulacji procesu przetłaczania zawiesiny. Uzyskane wyniki wskazują, że ciśnienie tłoczenia w pompie jest na wymaganym poziomie gdy nie występuje zablokowanie przepływu w rurze, i wykorzystane być mogą jako uzupełnienie teoretycznych metod optymalizacji parametrów układu transportowania i przetłaczania zawiesiny.
Źródło:
Archives of Mining Sciences; 2018, 63, 3; 647-663
0860-7001
Pojawia się w:
Archives of Mining Sciences
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Digital control system design for bearingless permanent magnet synchronous motors
Autorzy:
Sun, X.
Shi, Z.
Yang, Z.
Wang, S.
Su, B.
Chen, L.
Li, K.
Powiązania:
https://bibliotekanauki.pl/articles/202311.pdf
Data publikacji:
2018
Wydawca:
Polska Akademia Nauk. Czytelnia Czasopism PAN
Tematy:
BPMSMs
cyfrowy system kontroli
podwójnie zamknięty system regulacji prędkości
projektowanie oprogramowania
projekt sprzętu
digital control system
double-closed speed regulating system
software design
hardware design
Opis:
This study investigates a digital control system which is used in bearingless permanent magnet synchronous motors (BPMSMs). Compared with traditional permanent magnet synchronous motors, a BPMSM is characterized by higher speed and no mechanic friction. Therefore, the application value of the latter to the special area is higher than that of the former. An analysis from previous work on the BPMSM had proved its feasibility, and some performances such as suspension force, inductance and so on were also investigated. Based on this analysis, this study focuses on solving control problems in practical applications by designing a control system. The control system design includes overall schematic, hardware and software designs. Main software systems, including the force/current transform module and closed loop control module for radial displacement, are analyzed. Interface circuit for radial displacement, current feedback circuit and dead zone protection circuit are designed for the hardware system. Finally, several performance experiments have been conducted to verify the effectiveness of the designed digital control system. Experiment results indicate that the rotor has unique characteristics, such as stable suspension performance, good start-of-suspension performance, and rapid anti-disturbance features.
Źródło:
Bulletin of the Polish Academy of Sciences. Technical Sciences; 2018, 66, 5; 687-698
0239-7528
Pojawia się w:
Bulletin of the Polish Academy of Sciences. Technical Sciences
Dostawca treści:
Biblioteka Nauki
Artykuł
    Wyświetlanie 1-5 z 5

    Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies