Informacja

Drogi użytkowniku, aplikacja do prawidłowego działania wymaga obsługi JavaScript. Proszę włącz obsługę JavaScript w Twojej przeglądarce.

Wyszukujesz frazę "size of a test" wg kryterium: Wszystkie pola


Wyświetlanie 1-2 z 2
Tytuł:
Experimental investigation of the two-phase flow regimes and pressure drop in horizontal mini-size rectangular test section
Autorzy:
Elazhary, A.
Soliman, H.
Powiązania:
https://bibliotekanauki.pl/articles/239912.pdf
Data publikacji:
2012
Wydawca:
Polska Akademia Nauk. Czytelnia Czasopism PAN
Tematy:
dwufazowy
minikanał
przepływ
spadek ciśnienia
flow regimes
mini channel
pressure drop
two-phase
Opis:
An experimental study was conducted in order to investigate two-phase flow regimes and fully developed pressure drop in a mini-size, horizontal rectangular channel. The test section was machined in the form of an impacting tee junction in an acrylic block (in order to facilitate visualization) with a rectangular cross-section of 1.87-mm height on 20-mm width on the inlet and outlet sides. Pressure drop measurement and flow regime identification were performed on all three sides of the junction. Air-water mixtures at 200 kPa (abs) and room temperature were used as the test fluids. Four flow regimes were identified visually: bubbly, plug, churn, and annular over the ranges of gas and liquid superficial velocities of 0.04 [ less than or equal to] JG [ less than or equal to] 10 m/s and 0.02 [ less than or equal to] JL [ less than or equal to] 0.7 m/s, respectively, and a flow regime map was developed. Accuracy of the pressure-measurement technique was validated with single-phase, laminar and turbulent, fully developed data. Two-phase experiments were conducted for eight different inlet conditions and various mass splits at the junction. Comparisons were conducted between the present data and former correlations for the fully developed two-phase pressure drop in rectangular channels with similar sizes. Wide deviations were found among these correlations, and the correlations that agreed best with the present data were identified.
Źródło:
Archives of Thermodynamics; 2012, 33, 2; 47-6
1231-0956
2083-6023
Pojawia się w:
Archives of Thermodynamics
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Grain size reduction in the 713C nickel superalloy as a result of heat treatment
Autorzy:
Lachowicz, M. B.
Faryna, M.
Podrez-Radziszewska, M.
Powiązania:
https://bibliotekanauki.pl/articles/379754.pdf
Data publikacji:
2011
Wydawca:
Polska Akademia Nauk. Czytelnia Czasopism PAN
Tematy:
heat treatment
metallographic test
superalloy 713C
Ni3Al
NbC
EBSD method
obróbka cieplna
badanie metalograficzne
nadstop 713C
metoda EBSD
Opis:
The paper presents metallographic test results for the 713C nickel superalloy after heat treatment and crystallographic orientation analysis performed with the EBSD method. The 713C alloy was subjected to annealing in the temperature of 950 ºC for 30 hours followed by aircooling. As a result of the applied heat treatment the local grain size reduction in the alloy was observed. It has been found that in the primary grains the new subgrains of different crystallographic orientation are created. Between the new grains and the primary grains the boundaries of high angle appear. Orientation change in the micro-areas is closely related to the carbides rebuilding and volume diffusion of elements dissolved in the γ - γ’ alloy matrix and the (NbTi)C carbides.
Źródło:
Archives of Foundry Engineering; 2011, 11, 2 spec.; 143-148
1897-3310
2299-2944
Pojawia się w:
Archives of Foundry Engineering
Dostawca treści:
Biblioteka Nauki
Artykuł
    Wyświetlanie 1-2 z 2

    Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies