Informacja

Drogi użytkowniku, aplikacja do prawidłowego działania wymaga obsługi JavaScript. Proszę włącz obsługę JavaScript w Twojej przeglądarce.

Wyszukujesz frazę "reaction rate" wg kryterium: Temat


Wyświetlanie 1-2 z 2
Tytuł:
Copper adsorption reaction rate and ion exchange ratio during the copper activation of sphalerite
Autorzy:
Liu, J.
Luo, D.
Huang, L.
Wang, Y.
Wen, S.
Powiązania:
https://bibliotekanauki.pl/articles/110651.pdf
Data publikacji:
2018
Wydawca:
Politechnika Wrocławska. Oficyna Wydawnicza Politechniki Wrocławskiej
Tematy:
sphalerite
copper activation
solution chemistry
ion exchange ratio
reaction rate
Opis:
A theoretical analysis method of the solution chemistry characteristic of Cu(II) at various pH values was developed. Using such method, the existence form of Cu species and their proportions in aqueous solution can be clearly determined. After that, the copper adsorption and ion exchange ratio (E) during the copper activation of sphalerite were investigated. The results indicated that the copper activation of sphalerite can be divided into two stages, i.e., the fast activation stage (t ≤4 min) and slow activation stage (t >4 min). The general form of the copper adsorption rate was determined as ΓCu=K1ln(t) +Γ1, which is confirmed by the data fitting of the fast activation stage. The lower activation pH results in higher ion exchange efficiency for Cu substituting Zn. For a strong acid pH of 4.1, the E maintains about 1:1 in the entire activation time range and is not dependent on the activation time. However, the value of E is greater than 1 under weak acidic (pH=6.2) and alkaline (pH=9.1) pH conditions and it significantly depends on the activation time. For such conditions, E decreases with increase in the activation time, which supports the ion exchange mechanism, but within short activation time, it is not a 1:1 ion exchange process.
Źródło:
Physicochemical Problems of Mineral Processing; 2018, 54, 2; 377-385
1643-1049
2084-4735
Pojawia się w:
Physicochemical Problems of Mineral Processing
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Direct measurements of reaction time for extractive processes
Autorzy:
Gotfryd, L.
Becker, K.
Pietek, G.
Szołomicki, Z.
Piwowonska, J.
Powiązania:
https://bibliotekanauki.pl/articles/109772.pdf
Data publikacji:
2016
Wydawca:
Politechnika Wrocławska. Oficyna Wydawnicza Politechniki Wrocławskiej
Tematy:
reaction time
solvent extraction
viscosity
stripping rate
sulphuric acid
Opis:
Extraction times for selected metal cations (Mg2+, Al3+, Zn2+, Cd2+, Cu2+, Ni2+, Co2+, Mn2+, Fe2+ and Fe3+) have been measured using cation-exchanging extractants - Versatic 10 (neodecanoic acid), DEHPA (bis(2-ethylhexyl)phosphoric acid) and Cyanex 272 (bis(2,4,4-trimetylpentyl)phosphinic acid). Data was collected directly by measuring and recording pH of the two phase reaction mixture with maintaining continuity of the aqueous phase. Similarly, the stripping rate of selected cations (Mg2+, Al3+, Zn2+, Cu2+, Ni2+, Co2+) in a sulphuric acid solution was measured. Viscosities of organic phases, saturated with cations, were measured before their stripping. Additionally, the extraction dependence of Mg2+, Al3+, Fe2+ and Fe3+ on pH was measured using Versatic 10 at various concentrations (7.5, 15 and 30 %).
Źródło:
Physicochemical Problems of Mineral Processing; 2016, 52, 2; 909-919
1643-1049
2084-4735
Pojawia się w:
Physicochemical Problems of Mineral Processing
Dostawca treści:
Biblioteka Nauki
Artykuł
    Wyświetlanie 1-2 z 2

    Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies