Informacja

Drogi użytkowniku, aplikacja do prawidłowego działania wymaga obsługi JavaScript. Proszę włącz obsługę JavaScript w Twojej przeglądarce.

Wyszukujesz frazę "Yu, F." wg kryterium: Autor


Wyświetlanie 1-6 z 6
Tytuł:
Effect of spodumene leaching with sodium hydroxide on its flotation
Autorzy:
Yu, F.
Wang, Y.
Zhang, L.
Powiązania:
https://bibliotekanauki.pl/articles/110505.pdf
Data publikacji:
2015
Wydawca:
Politechnika Wrocławska. Oficyna Wydawnicza Politechniki Wrocławskiej
Tematy:
spodumene
flotation
preferential leaching
XPS analysis
Opis:
Effects of NaOH on flotation of spodumene, quartz and feldspar using oleic acid as a collector were investigated through microflotation and bench scale flotation tests. It was determined that NaOH acted more than a pH regulator in the tests. The X-ray photoelectron spectroscopy revealed that spodumene was preferentially leached by conditioning with high concentration of NaOH in the solution and exposed more Li positive sites on the mineral surface leading to an improved flotation.
Źródło:
Physicochemical Problems of Mineral Processing; 2015, 51, 2; 745-754
1643-1049
2084-4735
Pojawia się w:
Physicochemical Problems of Mineral Processing
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Investigation on different behavior and mechanism of Ca(II) and Fe(III) adsorption on spodumene surface
Autorzy:
Yu, F.
Wang, Y.
Wang, J.
Xie, Z.
Powiązania:
https://bibliotekanauki.pl/articles/110230.pdf
Data publikacji:
2014
Wydawca:
Politechnika Wrocławska. Oficyna Wydawnicza Politechniki Wrocławskiej
Tematy:
spodumene surface
calcium ions
iron ions
adsorption mechanism
DFT calculation
Opis:
Behavior and mechanism of Ca2+ and Fe3+ adsorption on spodumene surface were investigated by micro flotation tests, zeta potential measurements, and density functional theory (DFT) calculation methods. The micro flotation tests showed that Ca2+ and Fe3+ activated the flotation of spodumene remarkably. However, the effect of Fe3+ was more significant than that of Ca2+. Additionally, Fe3+ significantly changed the zeta potential of spodumene while Ca2+ showed a little change. Meanwhile, the calculated adsorption energy of Fe3+ on spodumene surface was much greater than that of Ca2+ indicating that Fe3+ is more apt to be adsorbed on spodumene surface than Ca2+. The value of bond population in Ca-O illustrated that the bond of Ca-O consists of partial covalent proportion and some ionic component. On the contrary, the bond of Fe-O showed a relatively strong covalent property. The partial density of states (PDOS) of free Ca/Fe and the reacted O atom on spodumene (110) surface before and after the adsorption showed that Fe 3d orbital and O 2p orbital formed hybridization. The density of states (DOS) near the Fermi level of spodumene surface after adsorption with Fe3+ was much stronger than that with Ca2+.
Źródło:
Physicochemical Problems of Mineral Processing; 2014, 50, 2; 535-550
1643-1049
2084-4735
Pojawia się w:
Physicochemical Problems of Mineral Processing
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Improving spodumene flotation using a mixed cationic and anionic collector
Autorzy:
Wang, Y.
Zhu, G.
Yu, F.
Lu, D.
Wang, L.
Zhao, Y.
Zheng, H.
Powiązania:
https://bibliotekanauki.pl/articles/109883.pdf
Data publikacji:
2018
Wydawca:
Politechnika Wrocławska. Oficyna Wydawnicza Politechniki Wrocławskiej
Tematy:
spodumene
lithium
silicates
flotation
anionic surfactant
cationic surfactant
Opis:
Lithium, a rare-earth element, has been in increasing demand. Spodumene flotation is an important and challenging step for lithium extraction and production from lithium ore. In the present work, flotation tests for three pure minerals (i.e., spodumene, quartz and feldspar) and a real spodumene ore were carried out at laboratory scale. The results showed that YOA, a mixture of oleic acid and dodecylamine with the molar ration of 10:1, could be used as collector to produce a spodumene concentrate with grade of 5.59% Li2O from the feed ore with grade of 1.48% Li2O where 85.24% of Li2O was recovered to the concentrate. The measured zeta potential, contact angle and adsorption capacity indicated that YOA was preferentially adsorbed on spodumene instead of on quartz or feldspar, with the spodumene surface being more hydrophobic than that of feldspar or quartz. The adsorption energies of YOA on spodumene were calculated and the results provided insights into the superior flotation performance obtained in the present work.
Źródło:
Physicochemical Problems of Mineral Processing; 2018, 54, 2; 567-577
1643-1049
2084-4735
Pojawia się w:
Physicochemical Problems of Mineral Processing
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Use of nanofiltration membranes to concentrate and recover leached aluminum from acidified water treatment sludge
Autorzy:
Cheng, W. P.
Chen, P. H.
Tian, D. R.
Yu, R. F.
Fu, C. H.
Powiązania:
https://bibliotekanauki.pl/articles/208030.pdf
Data publikacji:
2016
Wydawca:
Politechnika Wrocławska. Oficyna Wydawnicza Politechniki Wrocławskiej
Tematy:
water purification
nanofiltration
acidic solutions
leaching
roztwory kwaśne
oczyszczanie wody
nanofiltracja
ługowanie
glin
Opis:
The recovery of aluminum from water purification sludge is usually performed by making the solution acidic or basic. However, for economic reasons and reasons of safety, excessive doses of acid or base should not be utilized. Accordingly, the aluminum concentration in the leached solution is typically limited, thus the recovered aluminum cannot be directly reused as a coagulant. A nanofiltration (NF) membrane can be used in the acidic solution to concentrate high-valence metal ions. There-fore, in this work, H2SO4 was utilized to leach Al3+ ions from water purification sludge. Then, the Al3+ ion solution was concentrated using a low-price NF membrane. The effect of natural organic matter on the Al3+ ion concentrating efficiency in the filtration process has been elucidated. Experimental results reveal that Al3+ ions were effectively prevented from passing through the NF membrane, enabling a highly concentrated aluminum solution to be obtained. However, the presence of organic compounds may reduce the efficiency of the concentration of Al3+ ions in the solution.
Źródło:
Environment Protection Engineering; 2016, 42, 3; 19-32
0324-8828
Pojawia się w:
Environment Protection Engineering
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Converged ultra-wideband and multi-level wired signal downstream transport over single wavelength in wavelength-division multiplexing passive optical network
Autorzy:
Ma, H
Wang, F.
Wang, W.
Zhang, X
Yu, Q.
Powiązania:
https://bibliotekanauki.pl/articles/174929.pdf
Data publikacji:
2015
Wydawca:
Politechnika Wrocławska. Oficyna Wydawnicza Politechniki Wrocławskiej
Tematy:
ultra-wideband (UWB)
multi-level amplitude switch keying (M-ASK)
wavelength-division multiplexing passive optical network (WDM-PON)
Opis:
Simultaneous providing services of ultra-wideband and wired signal over single wavelength can greatly decrease the complexity and reduce the costs of a wavelength-division multiplexing passive optical network. However, ultra-wideband signal occupies the spectrum range from 3.1 to 10.6 GHz, and a narrow idle frequency band (from 0 to 3.1 GHz) could be employed to transport wired signal with a limited rate. In this paper, we proposed a scheme to simultaneously provide ultra-wideband and wired services, in which the information rate of the wired signal is enhanced by employing a multi-level amplitude switch keying signal in the idle frequency band formed by ultra-wideband signal. In comparison with other advanced modulation formats used for wavelength-division multiplexing passive optical networks such as orthogonal frequency division multiplexing, multi-level amplitude switch keying signal can be easily received by using intensity modulation direct detection, which will greatly reduce the cost of end-users. Especially, if a multi-band ultra-wideband signal is substituted for the direct-sequence ultra-wideband signal, the available spectrum range to transport wired signal will be easily extended to 5 GHz as multi-band ultra-wideband signal has a narrower spectrum width and flexible center frequency, so 4-amplitude switch keying signal with a rate of 5 Gbaud will achieve an information rate of 10 Gbit/s.
Źródło:
Optica Applicata; 2015, 45, 4; 433-445
0078-5466
1899-7015
Pojawia się w:
Optica Applicata
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Comparison of float-sink and progressive release flotation of ground products of coal middlings
Autorzy:
Xie, W.
He, Y.
Luo, C.
Zhang, X.
Li, H.
Yu, J.
Wang, H.
Shi, F.
Powiązania:
https://bibliotekanauki.pl/articles/109500.pdf
Data publikacji:
2015
Wydawca:
Politechnika Wrocławska. Oficyna Wydawnicza Politechniki Wrocławskiej
Tematy:
coal middlings
float-sink
progressive release flotation
XPS
EDX
Opis:
An additional recovery of coking coal middlings can be utilized for increasing of the concentrate yield of coking coal. A combined flow sheet of comminution and flotation can realize this target. To investigate the effect of grinding process on further flotation of ground products, progressive release flotation tests were used to compare with the float-sink tests, which were regarded as a criterion. Coal middlings were ground by wet-milling with iron balls to <0.5 mm. Curves of ash vs. cumulative yields of sized products indicated that the concentrate yield of coal separated by progressive release flotation was lower than that of coal benefited by the float-sink test, with the same ash for four size fractions (0.5-0.25 mm, 0.25-0.125 mm, 0.125-0.074 mm and <0.074 mm). Distributions of elements conducted by energy disperse spectroscopy (EDX) showed that associated kaolinite was liberated and exposed on the surface. It led to the shift of local surface property from hydrophobicity to hydrophilicity. Meanwhile, analyses of chemical property performed by an X-Ray photoelectron spectrometer (XPS) depicted that the hydrophilic mineral FeOOH, which generated in the grinding process, was adsorbed on the coal surface. Flotation of the ground products were worsened due to the increase of hydrophilicity of the coal surface.
Źródło:
Physicochemical Problems of Mineral Processing; 2015, 51, 2; 675-684
1643-1049
2084-4735
Pojawia się w:
Physicochemical Problems of Mineral Processing
Dostawca treści:
Biblioteka Nauki
Artykuł
    Wyświetlanie 1-6 z 6

    Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies