Informacja

Drogi użytkowniku, aplikacja do prawidłowego działania wymaga obsługi JavaScript. Proszę włącz obsługę JavaScript w Twojej przeglądarce.

Wyszukujesz frazę "modul Younga" wg kryterium: Temat


Wyświetlanie 1-3 z 3
Tytuł:
Wpływ wysokiego ciśnienia i temperatury na wartości modułu Younga i współczynnika Poissona w wybranych typach skał
Influence of high pressure and temperature on Young modulus and Poisson ratio values for selected rock types
Autorzy:
Domonik, A.
Powiązania:
https://bibliotekanauki.pl/articles/2063064.pdf
Data publikacji:
2011
Wydawca:
Państwowy Instytut Geologiczny – Państwowy Instytut Badawczy
Tematy:
moduł Younga
współczynnik Poissona
wysoka temperatura
wysokie ciśnienie
wytrzymałość
odkształcalność
Young modulus
Poisson ratio
high temperature
high pressure
strength
strain
Opis:
W pracy przedstawiono wpływ wysokiego ciśnienia i temperatury na zmiany wartości statycznego modułu Younga (Est) i statycznego współczynnika Poissona (νst) w wybranych odmianach litologicznych skał. Wartości tych stałych materiałowych zmieniają się wraz ze wzrostem ciśnienia (P) i temperatury (T) w zależności od odmiany litologicznej. W piaskowcach występuje generalny trend – wartość modułu Younga rośnie wraz z głębokością. Podobna tendencja występuje w przypadku granitu. Na wartość modułu Younga w dolomitach zmiany ciśnienia i temperatury nie wpływają natomiast znacząco. Z kolei w anhydrytach obserwuje się bardzo duże oscylacje wartości i znaczne rozrzuty parametru w zależności od głębokości. W bazaltach na dużej głębokości (2000 m) obserwuje się zmianę trendu z rosnącego na malejący. Natomiast dla statycznego współczynnika Poissona (νst) nie obserwuje się wyraźnych trendów. Wartości tego współczynnika nie zależną ani od głębokości, ani od temperatury.
The study presents and discusses the influence of high pressure and temperature on changes of the value of static Young modulus (Est) and static Poisson ratio ( st) for selected lithological types. The values of these material constants are changing with increasing pressure and temperature in different ways depending on lithological types. For sandstones a general trend is observed – the value of Young modulus increases with depth. Similar tendency might be observed in case of granites. Changes of pressure and temperature do not affect dolomites significantly. For anhydrite high variations of Young modulus are observed depending on depth. For basalts at high depth (2000 m) increasing trend inverts into decreasing. Static Poisson ratio ( Vst) does not have clear trends. The values of the ratio do not depend on temperature and depth as well.
Źródło:
Biuletyn Państwowego Instytutu Geologicznego; 2011, 446 (1); 117--122
0867-6143
Pojawia się w:
Biuletyn Państwowego Instytutu Geologicznego
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Odkształcalność piaskowców w świetle zmian wilgotności i smukłości próbek
Deformability of sandstones in view of changes in humidity and slenderness ratio of samples
Autorzy:
Bukowska, M.
Powiązania:
https://bibliotekanauki.pl/articles/2075327.pdf
Data publikacji:
2015
Wydawca:
Państwowy Instytut Geologiczny – Państwowy Instytut Badawczy
Tematy:
wilgotność
smukłość
moduł Younga
moduł post-krytyczny
odkształcenia
piaskowce
Górnośląskie Zagłębie Węglowe
humidity
slenderness ratio
Young's modulus
post-critical modulus
strain
sandstones
Upper Silesian Coal Basin
Opis:
Natural humidity of rocks in the Upper Silesian Coal Basin results from the influence of mining activities and dewatering the rock mass. The state of humidity which best approximates laboratory rock tests to the conditions in the exploited rock mass is the capillary saturation state. Deformation properties of sandstones (Young’s modulus, post-peak failure modulus, critical strain, residual strain) were determined for samples of slenderness ratio of 1 and 2, which were loaded in a servo-controlled testing machine. In the samples of sandstones of different slenderness ratio, values of Young’s modulus decreased for the samples in dry-air condition and capillary saturation state. In the samples of rocks of different slenderness ratio, tested in the same state of humidity, an increase in the value of Young’s modulus was observed. The increase depends on grain size. Post-peak failure modulus of sandstones shows similar trends of changes depending on slenderness ratio, state of humidity of the samples and their grain size. In the conditions when the samples of sandstones of slenderness ratio of 1, were tested in two states of humidity, values of critical strain decreased by a few per cent. For the samples of greater slenderness ratio, which also were tested in two states of humidity there was an increase in the value of critical strain and in humidity. For the samples of slenderness ratio of 1 and 2 tested in dry-air condition and in capillary saturation state there was a decrease in the value of critical strain by a few tens percent. The trends of changes in values of residual strain are the same as of critical strain. Based on the conducted tests it was shown that humidity and slenderness ratio of the sandstone samples influence differently their deformability. Humidity has a greater influence on the value of Young’s modulus than slenderness ratio of the tested samples. For critical strain and residual strain it was demonstrated that slenderness ratio of the samples has a greater influence than humidity. Moreover, a greater influence of the value of residual strain, in comparison with the values of critical strain, was observed for sandstone samples of lower slenderness ratio.
Źródło:
Przegląd Geologiczny; 2015, 63, 10/3; 1230--1236
0033-2151
Pojawia się w:
Przegląd Geologiczny
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Polowe pomiary odkształcalności fliszowych masywów skalnych
Field measurements of the flysh rock mass deformability
Autorzy:
Bestyński, Z.
Powiązania:
https://bibliotekanauki.pl/articles/2074250.pdf
Data publikacji:
2014
Wydawca:
Państwowy Instytut Geologiczny – Państwowy Instytut Badawczy
Tematy:
bedrock deformability
Young's modulus Es and D
geophysical parameters Vp
geotechnical class RMR
geotechnical class KFG
odkształcalność
Moduł Younga Es i D
parametry geofizyczne Vp
geotechniczne klasy RMR i KFG
Opis:
Field deformability measurement for the purpose of hydrotechnical building were performed at the Flysch Carpathian area. Locating of such objects requires the deformability of bedrock to be estimated on an object scale, with regard to its size as well its influence on the bedrock. Measurement were realized with the use static and dynamic methods, for various surface and load time. Measurement methods for bedrock deformability assessment on object scale were discussed. Results of big-scale static surveys were positively verified by measurement of bedrock deformability of existing objects. Geophysical classification index KFG was pointed to be used for geophysical bedrock deformability evaluation.
Źródło:
Przegląd Geologiczny; 2014, 62, 10/2; 544--548
0033-2151
Pojawia się w:
Przegląd Geologiczny
Dostawca treści:
Biblioteka Nauki
Artykuł
    Wyświetlanie 1-3 z 3

    Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies