Informacja

Drogi użytkowniku, aplikacja do prawidłowego działania wymaga obsługi JavaScript. Proszę włącz obsługę JavaScript w Twojej przeglądarce.

Wyszukujesz frazę "Michalowski, K" wg kryterium: Autor


Wyświetlanie 1-2 z 2
Tytuł:
Selection of elastic suspension elements for the special use vehicle
Autorzy:
Borkowski, W.
Michalowski, B.
Paplinski, K.
Rybak, P.
Wysocki, J.
Powiązania:
https://bibliotekanauki.pl/articles/242198.pdf
Data publikacji:
2009
Wydawca:
Instytut Techniczny Wojsk Lotniczych
Tematy:
special vehicle
suspension
spring
elastic element
lateral tilt stabilizer
Opis:
The work analyzes the possibility of using a truck chassis in terms of installing a specific device. As part ofwork was selected the vehicle, identified the necessary geometric parameters and the mass allowing of modernization, with particular emphasis on the required structural changes in the front and rear suspension. To this were used, the developed two phase methodology of calculation of the metal elastic elements (springs) and mechanical lateral tilt stabilizers. Results of numerical calculations are presented in the form of recommendations to redesign of the front and rear suspension. However, in the front suspension should be made a new spring and a mechanical lateral tilt stabilizer, while rear spring suspension meets the requirements in terms of elastic characteristics (adequate the coefficient of rigidity) is requiredonly adjustment of the static deflection of the suspension for example by adjusting the radii of leaf of the spring. Because of the design solution of the driving rear axle (so called driving axle trolley) was not proposed mechanical lateral tilt stabilizer. Paper present diagram of the forces acting on a vehicle with special equipment, results of the calculation loads acting on the suspension components fitted to a lorry with a special device, results of the calculation loads acting on the base vehicle suspension components, the basic parameters of a lorry with special hull and performance graph of the front suspension leaf spring resilience.
Źródło:
Journal of KONES; 2009, 16, 3; 47-54
1231-4005
2354-0133
Pojawia się w:
Journal of KONES
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Operational loads of combat vehicles
Autorzy:
Borkowski, W.
Rybak, P.
Hryciów, Z.
Wysocki, J.
Papliński, K.
Michałowski, B.
Powiązania:
https://bibliotekanauki.pl/articles/244652.pdf
Data publikacji:
2011
Wydawca:
Instytut Techniczny Wojsk Lotniczych
Tematy:
combat vehicles
maintenance
modeling and experimental research
Opis:
The paper describes dynamic load-generating sources and their effects on combat vehicles (CV), placed people and equipment within it. The variety of the operation conditions causes a complex dynamic load, both in terms of level, direction and distribution. The effects of the impacts are shown in photographs. It is important to know the level of loads in terms of the development of resistant and safe high-speed tracked combat vehicles. The selected results of its own researches of high-speed tracked combat vehicles were presented. Research were carried out under conditions similar to those typical for this class of vehicles, both during the rides on the road, the ground and obstacles on the specially constructed for this purpose. The results of research and analysis are compared in the form of graphs and the estimated value. The paper presents angular movement of the hull of the CV as well as displacements of carrying wheels during overcoming a single obstacle, elastic characteristics of hydro-pneumatic suspension components, distribution of pressure acting on a selected area of the bottom of the hull after mine explosion and power spectral density estimator of tank gun vibration as well as being the source longitudinal vibration of the hull tank. The presented scope and methodology allows the multi-variants investigation and estimate the loads of the hall, interior fittings and people in special vehicles and other objects that may be exposed to this type of loads.
Źródło:
Journal of KONES; 2011, 18, 1; 77-84
1231-4005
2354-0133
Pojawia się w:
Journal of KONES
Dostawca treści:
Biblioteka Nauki
Artykuł
    Wyświetlanie 1-2 z 2

    Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies