Informacja

Drogi użytkowniku, aplikacja do prawidłowego działania wymaga obsługi JavaScript. Proszę włącz obsługę JavaScript w Twojej przeglądarce.

Wyszukujesz frazę "Impurity" wg kryterium: Temat


Wyświetlanie 1-2 z 2
Tytuł:
Effect of polyacrylamide on the process of removing impurities in the rare earth leachate
Autorzy:
Wu, Xiaoyan
Zhou, Fang
Liu, Chufan
Feng, Jian
Zhang, Zhenyue
Chi, Ruan
Powiązania:
https://bibliotekanauki.pl/articles/1448504.pdf
Data publikacji:
2021
Wydawca:
Politechnika Wrocławska. Oficyna Wydawnicza Politechniki Wrocławskiej
Tematy:
polyacrylamide
rare earth leachate
impurity removal
flocs
Opis:
The impurity removal process of the rare earth (RE) leachate is usually accompanied by the formation of flocs, and a certain amount of polyacrylamide flocculant needs to be added in this process. However, few studies have investigated the effect of the flocculant on the impurity removal process. Therefore, this paper compares the influence on the process of removing impurities with or without the adding of polyacrylamide (PAM). The results showed that the addition of PAM had little effect on the removal rate of impurities, but it was conducive to the recovery of RE. When ammonium bicarbonate was firstly adopted to regulate the solution pH to 5.0, and then sodium sulfide was used to adjust the pH to 5.2, and 0.5 mL/100 mL of PAM was added to the leachate, 96% $Al^{3+}$ and 98% $Zn{2+}$ were removed from the leachate, while 95% RE was maintained. In addition, PAM could accelerate the settlement of flocs and then shorten the production cycle. The increase in RE recovery rate may be due to the addition of PAM to shorten the settling time of the flocs, thereby reducing the RE ions adsorbed during the flocculation process and increasing the recovery rate of the RE.
Źródło:
Physicochemical Problems of Mineral Processing; 2021, 57, 1; 182-191
1643-1049
2084-4735
Pojawia się w:
Physicochemical Problems of Mineral Processing
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Comparative study on removal of metallurgical silicon impurities by different acid leaching methods
Autorzy:
Gao, Zijie
Luo, Dawei
Powiązania:
https://bibliotekanauki.pl/articles/24085856.pdf
Data publikacji:
2023
Wydawca:
Politechnika Wrocławska. Oficyna Wydawnicza Politechniki Wrocławskiej
Tematy:
metallurgical-grade silicon
hydrometallurgy
acid leaching
impurity removal efficiency
Opis:
Hydrometallurgy is considered a promising method to produce solar-grade silicon (SOG-Si) from metallurgical-grade silicon (MG-Si) due to its advantages of low cost, simple operation, and easy control. In this paper, the effects of particle size of MG-Si, type of acid, leaching time, temperature, and liquid-to-solid ratio on the purification efficiency were investigated in an external field environment with the addition of ultrasound. The purification efficiencies of the two acid-leaching methods were compared. It was found that the simultaneous use of HCl + HNO3 was more effective than using only HCl for impurity removal in MG-Si: the extraction efficiencies of impurities Fe and Al were increased by 2.2% and 13.4%, respectively. The impurity contents in MG-Si before and after calcination pretreatment were also compared. This paper is expected to help researchers select the appropriate hydrometallurgical technique to reduce the impurity content in MG-Si.
Źródło:
Physicochemical Problems of Mineral Processing; 2023, 59, 2; art. no. 162331
1643-1049
2084-4735
Pojawia się w:
Physicochemical Problems of Mineral Processing
Dostawca treści:
Biblioteka Nauki
Artykuł
    Wyświetlanie 1-2 z 2

    Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies