Informacja

Drogi użytkowniku, aplikacja do prawidłowego działania wymaga obsługi JavaScript. Proszę włącz obsługę JavaScript w Twojej przeglądarce.

Wyszukujesz frazę "fault tolerant control" wg kryterium: Wszystkie pola


Wyświetlanie 1-6 z 6
Tytuł:
Fault-tolerant control for three-phase three-level T-type inverters with a redundant leg
Autorzy:
Chen, Danjiang
Zheng, Liyuan
Powiązania:
https://bibliotekanauki.pl/articles/2172799.pdf
Data publikacji:
2022
Wydawca:
Polska Akademia Nauk. Czytelnia Czasopism PAN
Tematy:
fault diagnosis
fault-tolerant control
open-circuit fault
phase-leg fault
redundant leg
T-type inverter
Opis:
Three-level T-type inverters have lower total harmonic distortion in output voltage, higher power density and lower voltage stress of power switches compared with conventional two-level inverters and have been widely used in applications with a wide-power range. Reliability improvement is particularly important for the T-type inverters because of the increased number of power switches and high system complexity. This paper proposes a fault-tolerant topology, which is constructed by adding a redundant leg including halfbridge switches and neutral-point switches connected between the DC bus capacitors and the DC-link midpoint of the conventional T-type inverter. In addition, an after-fault control strategy is proposed based on the results of a fault diagnosis method using bridge voltage. The fault-tolerant control of the open-circuit fault of the power switches and the phase-leg fault can both be achieved by the proposed method. Experimental results are given to verify that the proposed fault-tolerant three-level T-type inverter can output the full voltage level and power during the fault-tolerant operation based on the proposed control strategy.
Źródło:
Archives of Electrical Engineering; 2022, 71, 4; 931--948
1427-4221
2300-2506
Pojawia się w:
Archives of Electrical Engineering
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Application of rotor position sensor fault tolerant control in electric vehicle with PM BLDC motor drives
Autorzy:
Skóra, M.
Powiązania:
https://bibliotekanauki.pl/articles/140658.pdf
Data publikacji:
2018
Wydawca:
Polska Akademia Nauk. Czytelnia Czasopism PAN
Tematy:
PM BLDC motor
Hall effect sensor
fault tolerant drive
ZOA
electric vehicle
Opis:
In order to develop a PM BLDC motor control system, which will be tolerant of selected faults, simulation work was first performed and then verified on a universal test stand. The results were published in earlier works. The next stage of works was the implementation of previously developed algorithms on the target research test stand – in this case, the prototype vehicle. This last stage of the laboratory work has been presented in this article, i.e. it has been presented the results of experimental research related to the reproduction of rotor angle position, used after the detection of a rotor position sensor fault. A new test stand with the laboratory prototype of a vehicle with two PM BLDC motors is presented. A zeroth-order algorithm (ZOA) was used as a fault compensation method. The effectiveness and usefulness of the previously proposed methods have been confirmed.
Źródło:
Archives of Electrical Engineering; 2018, 67, 4; 725-738
1427-4221
2300-2506
Pojawia się w:
Archives of Electrical Engineering
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Observer-based fault diagnosis and field oriented fault tolerant control of induction motor with stator inter-turn fault
Autorzy:
Toumi, D.
Boucherti, M.S.
Tadjine, M.
Powiązania:
https://bibliotekanauki.pl/articles/140500.pdf
Data publikacji:
2012
Wydawca:
Polska Akademia Nauk. Czytelnia Czasopism PAN
Tematy:
silnik indukcyjny
zwarcie
sterowanie wektorowe
błąd diagnostyczny
induction motor
short circuit
fault-tolerant control
fault diagnostic
Opis:
This paper describes a fault-tolerant controller (FTC) of induction motor (IM) with inter-turn short circuit in stator phase winding. The fault-tolerant controller is based on the indirect rotor field oriented control (IRFOC) and an observer to estimate the motor states, the amount of turns involved in short circuit and the current in the short circuit. The proposed fault controller switches between the control of the two components of measured stator current in the synchronously rotating reference frame and the control of the two components of estimated current in the case of faulty condition when the estimated current in the short circuit is not destructive of motor winding. This technique is used to eliminate the speed and the rotor flux harmonics and to assure the decoupling between the rotor flux and torque controls. The results of the simulation for controlling the speed and rotor flux of the IM demonstrate the applicability of the proposed FTC.
Źródło:
Archives of Electrical Engineering; 2012, 61, 2; 165-188
1427-4221
2300-2506
Pojawia się w:
Archives of Electrical Engineering
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
A hybrid active fault-tolerant control scheme for wind energy conversion system based on permanent magnet synchronous generator
Autorzy:
Tahri, A.
Hassaine, S.
Moreau, S.
Powiązania:
https://bibliotekanauki.pl/articles/140788.pdf
Data publikacji:
2018
Wydawca:
Polska Akademia Nauk. Czytelnia Czasopism PAN
Tematy:
wind energy conversion system
active fault-tolerant control
permanent magnet synchronous generator
sensor fault diagnosis
sliding mode observer
Opis:
Wind energy has achieved prominence in renewable energy production. There- fore, it is necessary to develop a diagnosis system and fault-tolerant control to protect the system and to prevent unscheduled shutdowns. The presented study aims to provide an experimental analysis of a speed sensor fault by hybrid active fault-tolerant control (AFTC) for a wind energy conversion system (WECS) based on a permanent magnet synchronous generator (PMSG). The hybrid AFTC switches between a traditional controller based on proportional integral (PI) controllers under normal conditions and a robust backstepping controller system without a speed sensor to avoid any deterioration caused by the sensor fault. A sliding mode observer is used to estimate the PMSG rotor position. The proposed controller architecture can be designed for performance and robustness separately. Finally, the proposed methodwas successfully tested in an experimental set up using a dSPACE 1104 platform. In this experimental system, the wind turbine with a generator connection via a mechanical gear is emulated by a PMSM engine with controled speed through a voltage inverter. The obtained experimental results show clearly that the proposed method is able to guarantee service production continuity for the WECS in adequate transition.
Źródło:
Archives of Electrical Engineering; 2018, 67, 3; 485--497
1427-4221
2300-2506
Pojawia się w:
Archives of Electrical Engineering
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Analysis of fault states in drive systems with multi-phase induction motors
Autorzy:
Listwan, Jacek Jan
Powiązania:
https://bibliotekanauki.pl/articles/141008.pdf
Data publikacji:
2019
Wydawca:
Polska Akademia Nauk. Czytelnia Czasopism PAN
Tematy:
Direct Field-Oriented Control method
Fault Tolerant Control
MRASCC estimator
multi-phase squirrel-cage induction moto sensorless drives
Voltage Source Inverter faults
Opis:
The paper presents the analysis of different fault states in drive systems with multiphase induction motors. The mathematical models of a five-phase and six-phase induction motor and the MRASCC estimator have been presented and the description of the Space Vector Modulation has been shown. The Direct Field-Oriented Control (DFOC) system is analyzed. Results of the simulation and experimental studies of the Direct Field-Oriented Control systems in the fault conditions are presented. The author’s original contribution includes analysis and studies of the DFOC control method of a five-phase induction motor resistant to the motor speed sensor fault with the use of the MRASCC estimator.
Źródło:
Archives of Electrical Engineering; 2019, 68, 4; 817-830
1427-4221
2300-2506
Pojawia się w:
Archives of Electrical Engineering
Dostawca treści:
Biblioteka Nauki
Artykuł
Tytuł:
Model predictive control of NPC three-level grid-tied converter based on reconstructed current
Autorzy:
Li, Yanyan
Xiao, Han
Jin, Nan
Yan, Guanglu
Powiązania:
https://bibliotekanauki.pl/articles/2086686.pdf
Data publikacji:
2022
Wydawca:
Polska Akademia Nauk. Czytelnia Czasopism PAN
Tematy:
current reconstruction
current sensor fault
fault-tolerant
model predictive control
neutral point clamped three-level converter
Opis:
The neutral point clamped (NPC) three-level grid-tied converter is the key equipment connecting renewable energy and power grids. The current sensor fault caused by harsh environment may lead to the split of renewable energy. The existing sensor fault-tolerant methods will reduce the modulation ratio index of the converter system. To ensure continuous operation of the converter system and improve the modulation index, a model predictive control method based on reconstructed current is proposed in this paper. According to the relationship between fault phase current and a voltage vector, the original voltage vector is combined and classified. To maintain the stable operation of the converter and improve the utilization rate of DC voltage, two kinds of fault phase current are reconstructed with DC current, normal phase current and predicted current, respectively. Based on reconstructed three-phase current, a current predictive control model is designed, and a model predictive control method is proposed. The proposed method selects the optimal voltage vector with the cost function and reduces time delay with the current reconstruction sector. The simulation and experimental results show that the proposed strategy can keep the NPC converter running stably with one AC sensor, and the modulation index is increased from 57.7% to 100%.
Źródło:
Archives of Electrical Engineering; 2022, 71, 2; 363--377
1427-4221
2300-2506
Pojawia się w:
Archives of Electrical Engineering
Dostawca treści:
Biblioteka Nauki
Artykuł
    Wyświetlanie 1-6 z 6

    Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies