Currently, process optimization is an important part of design of CNC toolpath, allowing overall process improvement in accordance to a range of criteria. Available CAE software for CNC toolpath optimization works only by changing the feed rate value specified in the base toolpath. The authors are planning to devise a solution allowing for optimization of other process parameters, including depth of cut. In some cases, it would be important for surface roughness to remain unaltered after optimization by means of increasing depth of cut. In this work, the effect of depth of cut on surface roughness was investigated. Depth of cut was altered for the roughing pass, while technological parameters for the finish pass remained constant. Roughness measurements were performed on-machine after rough turning and finish turning. The authors have found that depth of cut has a noticeable effect on investigated roughness parameters, both in the case of rough turning and subsequent finish turning operations.
Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies
Informacja
SZANOWNI CZYTELNICY!
UPRZEJMIE INFORMUJEMY, ŻE BIBLIOTEKA FUNKCJONUJE W NASTĘPUJĄCYCH GODZINACH:
Wypożyczalnia i Czytelnia Główna: poniedziałek – piątek od 9.00 do 19.00