This article presents results of experimental tests of internal cylindrical traverse grinding in which the total machining allowance is removed in a single pass. Grinding wheels with zone-diversified structure made on basis of abrasive grains from Al2O3 were used in the process. Such tools are characterized by different construction of rough and finish grinding zones. Moreover, conic chamfer is shaped on their active surface that allows for even distribution of machining allowance on the grinding wheel surface. What is described in the hereby work is a device for precise shaping of conic chamfer on the grinding wheel active surface (GWAS). The work also presents results of tests whose aim was to determine the influence of grinding wheel macrogeometry on the process of internal cylindrical traverse grinding of internal cylindrical surfaces made from steel 100Cr6. Changes of selected parameters of the machined surface geometric structure (Ra, Rz, RSm, Rdq and RTp) and values of the grinding power P were analyzed. It was proved that the greater the conic chamfer width, the better the results.
Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies
Informacja
SZANOWNI CZYTELNICY!
UPRZEJMIE INFORMUJEMY, ŻE BIBLIOTEKA FUNKCJONUJE W NASTĘPUJĄCYCH GODZINACH:
Wypożyczalnia i Czytelnia Główna: poniedziałek – piątek od 9.00 do 19.00