The shape and type of chip give general information about the cutting process. This paper presents the results of testing the shape and type of chips of Ti6Al4V titanium alloy after it finishes turning. The process was carried out under dry, wet and MQL (Minimum Quantity Lubrication) conditions at variable cutting speeds and feed rates and a constant depth of cutting. For planning the tests, the PSI (Parameter Space Investigation) method was used, which allows the experiment to be carried out while minimizing the number of experience points. It was found that the cutting speed and feed affect the type and shape of the chip, and clear differences were observed between dry and wet cooling conditions, and MQL conditions. During turning, the intensity of the cutting speed and feed influence on the chip compression ratio was changed. It was similar for dry and wet cooling conditions but smaller for MQL conditions. The purpose of this research is to analyze the chip shaping when Ti6Al4V titanium alloy finishes turning under dry, wet and MQL cooling conditions.
Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies
Informacja
SZANOWNI CZYTELNICY!
UPRZEJMIE INFORMUJEMY, ŻE BIBLIOTEKA FUNKCJONUJE W NASTĘPUJĄCYCH GODZINACH:
Wypożyczalnia i Czytelnia Główna: poniedziałek – piątek od 9.00 do 19.00