This paper examines various control locations in heavy mining vehicles. Three trucks have been tested on a skid pad in both clockwise and anticlockwise directions. The skid lengths were measured after each trial. The primary focus of the study was the positioning of various controls and their relevance to various skid lengths. Some additional measures such as NASA-TLX scales were also used to make subjective evaluations. The results are presented in this paper. The findings clearly indicate the relevance of control locations to actual skid lengths. The poorly located controls resulted in greater skid lengths. This is an important finding as skid lengths are related to greater reaction times in a skidding situation and hence greater risk of accidents on relevant trucks. Such accidents can incur large repair bills for damaged equipment whereas more importantly, jeopardizing the life and safety of heavy mining vehicle drivers.
Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies
Informacja
SZANOWNI CZYTELNICY!
UPRZEJMIE INFORMUJEMY, ŻE BIBLIOTEKA FUNKCJONUJE W NASTĘPUJĄCYCH GODZINACH:
Wypożyczalnia i Czytelnia Główna: poniedziałek – piątek od 9.00 do 19.00