Projekt urządzenia ogrzewania wody z wtórnym wykorzystaniem energii z systemów chłodzenia Design of a water heating tank based on utilization of the waste heat energy of refrigerants
W artykule przedstawiono propozycję konstrukcji naczynia do
ogrzewania wody do celów socjalnych. Jako czynnik grzewczy w zaprojektowanym
systemie wykorzystano ciepło z obiegu wtórnego urządzeń
chłodniczych. Uzyskane wyniki na urządzeniu prototypowym (rys. 4)
pozwalają stwierdzić, że istnieje możliwość warstwowego ogrzewania
cieczy wewnątrz naczynia. Dzieje się to wówczas, jeśli do miejsca
wymiany ciepła dostarczana jest stale chłodna woda. Zaprojektowana
konstrukcja umożliwia wykorzystanie niskotemperaturowych źródeł
ciepła z obiegów chłodzących do ogrzewania wody, eliminując niebezpieczeństwo
przeniknięcia mediów.
In the contribution is submitted proposal of the vessel construction for water
for industrial use. For heating is being used the secondary heat from the cooling system.
More frequent utilization of this energy is limited of present by two facts: 1. The
cooling devices contain toxic charge and therefore the pipeline for cooling medium
passing through must not be in direct contact with the heated water for hygiene and
safety reasons. 2. Sufficient thermal difference for effective heat sharing is possible
only when the cool water is supplied to the place of heating.
The suggested construction solves both these problems. The primary pipeline
with ammonia is located on the container outer side into other heat-carrying protective
medium. The inner arrangement provides the isothermal water stratification in
container. In to the container is located the insert from non-conductive material with
outer dimension smaller than the inner diameter of container. This enables formation
of the slot filled by the heated water. Between the hot water in the slot and cold water
inside the vessel creates the pressure difference, heated water rises into the upper
part of the container and cold water is sucked into the slot from the bottom. Within
the heating almost whole container volume is therefore reached steady thermal gradient
between the heating and heated medium and maximum effectiveness of the
heat sharing.
After verification of the suggested construction the device prototype is manufactured
enabling monitoring of the temperature course in various parts of the device
in dependence on time. The temperature layout inside the container was monitored
by five thermal sensors located in the vessel centre line in distance of 150 mm
(Fig. 3). From the measuring results is evident the heated water stratification inside
the vessel. To the heating point is continuously supplied water of initial temperature
(Fig. 4) for 15 minutes. Nevertheless, from the measured temperature resulted that
the cooling medium secondary heat is not utilized sufficiently. The maximum output
of the device at the heating beginning is almost 5 kW. This it will be necessary to
extend the heat-exchanging surface of the exchanger or to adapt the slot shape along
the vessel periphery to reach lower flow rate of the heated water.
The described device will enable after the suggested adaptation the effective
utilization of the secondary heat of the cooling medium without risk of its penetration
into the heated water.
Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies
Informacja
SZANOWNI CZYTELNICY!
UPRZEJMIE INFORMUJEMY, ŻE BIBLIOTEKA FUNKCJONUJE W NASTĘPUJĄCYCH GODZINACH:
Wypożyczalnia i Czytelnia Główna: poniedziałek – piątek od 9.00 do 19.00