The paper presents an attempt to analyze comparative machinability of two different varieties
of nitinol alloy type, or compare the susceptibility of these materials to change the
volume, shape and dimension of adopted machining conditions. The machinability of the
material can not be fully determined numerically by only one independent factor. Therefore
multivariate analysis technique of weighted diagram radar was developed by authors. This
technique allowed for the comprehensive identification machinability analyzed varieties of
nitinol alloy exclusively on the basis of the specified in literature directional material properties
and general recommendations tool manufacturers on the cutting conditions. In the
paper the full usefulness of this technique to demonstrate the differences in machinability of
different varieties of the same species alloy, without the need for lengthy and cost-intensive
experimental trials was presented.
Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies
Informacja
SZANOWNI CZYTELNICY!
UPRZEJMIE INFORMUJEMY, ŻE BIBLIOTEKA FUNKCJONUJE W NASTĘPUJĄCYCH GODZINACH:
Wypożyczalnia i Czytelnia Główna: poniedziałek – piątek od 9.00 do 19.00