In paper researching results of tribological proprieties Fe3Al intermetallic alloys after annealing are presented. Studies were conducted in the following environments: a water; an air and oil. For investigation purposes the tribotester pin-on-disk type with the contrsample made of steel 40H quenched and tempered was used. Tests were carried out with the following process parameters: pressure p = 2MPa and linear velocity (circuital) V = 0.46m/s. It was noted, that intermetallic samples with the small distinction in chemical compositions, annealed at different temperatures showed a large difference in the quantity of material loss in the all tested environments. Appropriately selected parameters of the intermetallic alloys annealing, provide their greater resistance to abrasion in the air and oil environments than in the case of steel.
Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies
Informacja
SZANOWNI CZYTELNICY!
UPRZEJMIE INFORMUJEMY, ŻE BIBLIOTEKA FUNKCJONUJE W NASTĘPUJĄCYCH GODZINACH:
Wypożyczalnia i Czytelnia Główna: poniedziałek – piątek od 9.00 do 19.00