Carbon Fiber Reinforced Polymer (CFRP) is the most preferred composite material due to its high strength, high modulus,
corrosion resistance and rigidity and which has wide applications in aerospace engineering, automobile sector, sports instrumentation,
light trucks, airframes. This paper is an attempt to carry out drilling experiments as per Taguchi’s L27 (313) orthogonal array
on CFRP under dry condition with three different drill bit type (HSS, TiAlN and TiN). In this research work Response Surface
Analysis (RSA) is used to correlate the effect of process parameters (cutting speed and feed rate) on thrust force, torque, vibration
and surface roughness. This paper also focuses on determining the optimum combination of input process parameter and the
drill bit type that produces quality holes in CFRP composite laminate using Multi-objective Taguchi technique and TOPSIS. The
percentage of contribution, influence of process parameters and adequacy of the second order regression model is carried out by
analysis of variance (ANOVA). The results of experimental investigation demonstrates that feed rate is the pre-dominate factor
which affects the response variables.
Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies
Informacja
SZANOWNI CZYTELNICY!
UPRZEJMIE INFORMUJEMY, ŻE BIBLIOTEKA FUNKCJONUJE W NASTĘPUJĄCYCH GODZINACH:
Wypożyczalnia i Czytelnia Główna: poniedziałek – piątek od 9.00 do 19.00