Quantitative and qualitative evaluation of the influence of the applied sample morphology as well as parameters of deformation on the microstructure and selected properties of Ti-6Al-4V alloy after deformation was presented. Both cast Ti-6Al-4V alloy and powder compacts were used as the material under investigation. P/M preform was produced from the mixture of elemental powders, by hot compaction. The samples of compacts as well as cast alloy were subjected to plastometric tests under various conditions. The influence of the state of the investigated Ti-6Al-4V alloy on the character of flow curves was determined. The microstructure and hardness after deformation were evaluated and compared. Basing on the results of plastometric tests, the suitable thermo-mechanical parameters of forging of Ti-6Al-4V alloy were determined. The charge was machined from the compacts and from cast material, and both types of forging stock were hot-forged. The microstructure as well as hardness of the forgings were compared.
Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies
Informacja
SZANOWNI CZYTELNICY!
UPRZEJMIE INFORMUJEMY, ŻE BIBLIOTEKA FUNKCJONUJE W NASTĘPUJĄCYCH GODZINACH:
Wypożyczalnia i Czytelnia Główna: poniedziałek – piątek od 9.00 do 19.00