Microstructure and mechanical properties of the 316L steel composite reinforced with TiB2 phase were examined. The test
materials were obtained by SPS technique from powders. From testing of the mechanical properties it follows that the optimum
temperature for the fabrication of 316Lsteel-TiB2 composites by SPS is 1100°C. Studies have also proved that the critical content
of TiB2 phase in steel matrix should not exceed 6vol%. Above this level, the plastic properties of the composite become unstable
and strongly dependent on the time of sintering.
Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies
Informacja
SZANOWNI CZYTELNICY!
UPRZEJMIE INFORMUJEMY, ŻE BIBLIOTEKA FUNKCJONUJE W NASTĘPUJĄCYCH GODZINACH:
Wypożyczalnia i Czytelnia Główna: poniedziałek – piątek od 9.00 do 19.00