This paper presents a method based on the use of fuzzy logic for the rapid selection of optimal induction sintering parameters. The prepared fuzzy controller uses expert knowledge developed from the results of induction sintering tests of Ti-5Al-5Mo-5V-3Cr alloy green compacts produced from a mixture of elemental powders. The analysis of the influence of the applied sintering parameters on the material characteristics was based on the evaluation of the microstructure state and the measurement of the relative density of the samples after sintering. In this way, a universal tool for estimating the sintering parameters of titanium powder-based green compacts was obtained. It was shown that with the help of fuzzy logic it is possible to analyze the influence of the parameters of the manufacturing process of metal powder materials on the quality of the obtained products.
Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies
Informacja
SZANOWNI CZYTELNICY!
UPRZEJMIE INFORMUJEMY, ŻE BIBLIOTEKA FUNKCJONUJE W NASTĘPUJĄCYCH GODZINACH:
Wypożyczalnia i Czytelnia Główna: poniedziałek – piątek od 9.00 do 19.00