An experimental investigation was performed on the thermal
performance and heat transfer characteristics of acetone/zirconia nanofluid
in a straight (rod) gravity-assisted heat pipe. The heat pipe was fabricated
from copper with a diameter of 15 mm, evaporator-condenser length of
100 mm and adiabatic length of 50 mm. The zirconia-acetone nanofluid was
prepared at 0.05–0.15% wt. Influence of heat flux applied to the evaporator,
filling ratio, tilt angle and mass concentration of nanofluid on the heat
transfer coefficient of heat pipe was investigated. Results showed that the
use of nanofluid increases the heat transfer coefficient while decreasing the
thermal resistance of the heat pipe. However, for the filling ratio and tilt
angle values, the heat transfer coefficient initially increases with an increase
in both. However, from a specific value, which was 0.65 for filling ratio
and 60–65 deg for tilt angle, the heat transfer coefficient was suppressed.
This was attributed to the limitation in the internal space of the heat pipe
and also the accumulation of working fluid inside the bottom of the heat
pipe due to the large tilt angle. Overall, zirconia-acetone showed a great
potential to increase the thermal performance of the heat pipe.
Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies
Informacja
SZANOWNI CZYTELNICY!
UPRZEJMIE INFORMUJEMY, ŻE BIBLIOTEKA FUNKCJONUJE W NASTĘPUJĄCYCH GODZINACH:
Wypożyczalnia i Czytelnia Główna: poniedziałek – piątek od 9.00 do 19.00