The methane hazard is one of the natural hazards occurring in hard coal mining. The content of natural methane in hard coal seams, the so-called methane-bearing capacity, is one of the key parameters that allow for proper assessment of the methane hazard and the state of the threat of gas and rock outbursts. For safety purposes, there is a constant need to improve the methods for the determination of this parameter. In the conditions of Polish mining, the method used for methane-bearing capacity determination is the direct drill cuttings method. This paper contains a comparative study presenting three different methods of methane-bearing capacity determination. Tests were conducted using two direct methods (the drill cuttings method and the United States Bureau of Mines (USBM) method), and the indirect method based on the desorption intensity index. On the basis of the obtained test results, it was found that the results obtained with the USBM method were slightly higher than those obtained with the direct drill cuttings method. Gas losses, an important element affecting the final value of the assay, were also analysed. This comparative study will evaluate the validity and applicability of the above methods under specific conditions in hard coal mining.
Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies
Informacja
SZANOWNI CZYTELNICY!
UPRZEJMIE INFORMUJEMY, ŻE BIBLIOTEKA FUNKCJONUJE W NASTĘPUJĄCYCH GODZINACH:
Wypożyczalnia i Czytelnia Główna: poniedziałek – piątek od 9.00 do 19.00