In this work were analyzed factors and working conditions that leads to the wearing of junk mills tools that are a part of junk removal equipment used in drilling and workover of borehole. Such equipment is a part of oil and gas industry and work under condition of intense abrasive wearing with increased pressures and cyclic loads. Was established that traditional hardfacing materials based on the Fe-Cr-C system are not effective for improvement of abrasion resistance of elements of such equipment due to their low crack resistance and low hardness of chromium carbides. The aim of this work was to increase a durability of that equipment by using of flux cored electrodes with reaction components of pure metal powders, which leads to forming the fine-grained structure with increased hardness. Powders of Ti, Mo, B4C and their combinations were used. Structures of the hardfacing coatings were investigated by method of metallography, scanning electron microscopy (SEM). Abrasion wear tests were held under condition of fixed and non-fixed abrasion. Using of pure metal powders led to formation of a fine-grained structure with grains of Mo2FeB2 that forms around TiC, which work as modifier. It was investigated that the researched material based on Fe-Ti-Mo-C-B system that was used for increasing the wear resistance of junk mills led to increasing of the TBO period in 1.5-1.6 times comparing with serial hardfacing materials based on tungsten.
Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies
Informacja
SZANOWNI CZYTELNICY!
UPRZEJMIE INFORMUJEMY, ŻE BIBLIOTEKA FUNKCJONUJE W NASTĘPUJĄCYCH GODZINACH:
Wypożyczalnia i Czytelnia Główna: poniedziałek – piątek od 9.00 do 19.00