This article deals with vibration analysis and the processing of the vibration signal obtained during the experimental measurement on a rotary shaft at start-up, constant speed and run-out, with rolling ball bearings. The next step of the research is the introduction and application of mathematical and numerical methods for the processing of input and measured data using diagnostic and mathematical software. The principle of measurement and processing was to compare the results of oscillation of an undamaged bearing with several types of damaged bearings with corresponding deformations in the orbits/raceways. The purpose of this research and comparison was to achieve optimal results (in terms of amplitude values, the occurrence of eigenvalue vibrations and the resonance phenomenon) of individual bearings with corresponding deformations in the raceways and to obtain calibration diagrams as a tool for possible prediction of bearings in operation.
Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies
Informacja
SZANOWNI CZYTELNICY!
UPRZEJMIE INFORMUJEMY, ŻE BIBLIOTEKA FUNKCJONUJE W NASTĘPUJĄCYCH GODZINACH:
Wypożyczalnia i Czytelnia Główna: poniedziałek – piątek od 9.00 do 19.00