Steel yielding arch support constructed of V profiles is commonly used to protect galleries and, in some cases, to reinforce or secure a shaft support. For this purpose, a closed, circular-shaped arch support is used, with arches overlapped by clamps that are typical for this type of construction. The support has high resistance to the impact of even (distributed over the entire surface of the support) load, however, as a result of significant deformation associated with a change in the radius of the curvatures, the support shows limited yielding capacity. This is due to the increase in resistance to slide on the locks, resulting from changes in the geometry of the ring caused by the rock mass. This article presents the results of research and analysis concerning the elements of the arch support with notches in arches. The research team tested the effect of the depth and location of the notches of the section’s flanges on the load impacting on the clamp’s bolts and the strength of the roof support. Moreover, the tests covered the influence of the number and location of clamps in a frictional joint on the change in the nature of work and yielding capacity. Finally, the research included both strength tests of the support’s elements, as well as strength analyses based on the finite element method.
Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies
Informacja
SZANOWNI CZYTELNICY!
UPRZEJMIE INFORMUJEMY, ŻE BIBLIOTEKA FUNKCJONUJE W NASTĘPUJĄCYCH GODZINACH:
Wypożyczalnia i Czytelnia Główna: poniedziałek – piątek od 9.00 do 19.00