This article presents joining methods (welding and sealing) of single-polymer composite materials in a hot air stream. The research material was created using the film-stacking method, which involves pressing successive fractions of polyethylene terephthalate-modified with glycol (PET-G) at defined technological conditions, such as pressure, temperature, and time. Joining method analysis was carried out based on the tensile test results. Analysis of the obtained results showed that the properties of the overlapped weld joint were the best because they were closest to the original materials. In contrast, PET-G welded joint properties were the worst because the PET-G welded joint does not contain fibers, which enhanced the weld; therefore, the fastest breakage of the material was observed at the welding location. For the overlapped weld, the weld itself is more resistant because the joint surface is influenced by friction forces between joined materials.
Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies
Informacja
SZANOWNI CZYTELNICY!
UPRZEJMIE INFORMUJEMY, ŻE BIBLIOTEKA FUNKCJONUJE W NASTĘPUJĄCYCH GODZINACH:
Wypożyczalnia i Czytelnia Główna: poniedziałek – piątek od 9.00 do 19.00