In this paper, a special configuration for the huge multipurpose machine tool of “travelling column” type was investigated by the finite element analysis. Internal degrees of freedom of a bulky system consisting of the ram, stock, column, sledge and bed, were implemented by the hydrostatic guides. A simulation of coupling two assembled columns into the portal structure was completed. The results of this work showed that temporal joining raises the spindle static rigidity by 1.39–1.91 times depending on the direction (mostly longitudinal – along the X-axis). The simulation also revealed the robustness of a whole-machine resonance pattern (11.7–39.0 Hz) to “column–to–portal coupling”. Eight types of eigenmodes were analyzed for frequency intervals from 0 to 80 Hz. A decrease by 2.9 times of the resonance peaks of a frequency response function was observed in the case of a portal structure creation. In case of columns-to-portal transition, stable cutting just at resonance frequencies (resonance overriding) becomes allowable. Overall, the “Portal” structure is recommended for intermittent cutting machining by raised high spindle unit at frequencies below 40 Hz.
Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies
Informacja
SZANOWNI CZYTELNICY!
UPRZEJMIE INFORMUJEMY, ŻE BIBLIOTEKA FUNKCJONUJE W NASTĘPUJĄCYCH GODZINACH:
Wypożyczalnia i Czytelnia Główna: poniedziałek – piątek od 9.00 do 19.00