This article discusses the issues concerning the quality of casting surface with a small unit weight manufactured on the Disamatic automatic casting lines in a flaskless mould with a vertical parting line. The research was conducted in manufacturing conditions in one of the casting facilities in the country. The identification of casting defects for a monthly manufacturing cycle was made and agreed that the main causes of scrap casting are defects on the raw surface: lumps of moulding sand which after removal form cavities and draws as well as defects of gas origin such as blowholes. There are also defects of form namely short runs. In the later part of the work, the research results of the properties of moulding sand were presented and casting defects were selected the occurrence of which is connected with the quality of moulding sands.
Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies
Informacja
SZANOWNI CZYTELNICY!
UPRZEJMIE INFORMUJEMY, ŻE BIBLIOTEKA FUNKCJONUJE W NASTĘPUJĄCYCH GODZINACH:
Wypożyczalnia i Czytelnia Główna: poniedziałek – piątek od 9.00 do 19.00