The purpose of the present study was to simulate the equivalent circuit in the MATLAB software in order to implement the desired relationships for both continuous-conduction mode (CCM) and discontinuous-conduction mode (DCM), and to obtain the power and efficiency values at different frequencies. Then, it was necessary to optimize the effective values on the power by Particle Swarm Optimization (PSO) algorithm. After optimization, the optimization and pre-optimization results were compared and, if post-optimization results were not desirable, effective parameters should be reviewed before the optimization stage and the tunable parameters should be changed to achieve the desired results. This process will continue to obtain the optimization results. The results show that the highest efficiency is 98% in the DCM mode and 95% in the CCM mode. In both methods, we achieved more favorable results than the with the PSO method. However, the DCM mode provides an improvement which is about 2.6% higher than CCM.
Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies
Informacja
SZANOWNI CZYTELNICY!
UPRZEJMIE INFORMUJEMY, ŻE BIBLIOTEKA FUNKCJONUJE W NASTĘPUJĄCYCH GODZINACH:
Wypożyczalnia i Czytelnia Główna: poniedziałek – piątek od 9.00 do 19.00