The paper presents the results of examination of the proposal content and the scope of maintenance of the machining center MCFV 1050 Basic through the RCM II - Reliability Centered Maintenance method. Based on the analysis of apriori and parametric reliability methods, it was decided to use the FMEA for analyze the causes and consequences of failure states using the software IQ-RM PRO 6. The structure, defined functions and fault functions were developed.The analyzed types of failure and types of maintenance tasks were processed in the RCM II Information and Decision Making Reports.The result is 10 proposed maintenance tasks performed in time intervals, 8 maintenance tasks performed as needed and 1 maintenance task performed after the specified performance.The end of the article discusses the suitability of the applied methods for the maintenance proposal and of the defined recommendations.
Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies
Informacja
SZANOWNI CZYTELNICY!
UPRZEJMIE INFORMUJEMY, ŻE BIBLIOTEKA FUNKCJONUJE W NASTĘPUJĄCYCH GODZINACH:
Wypożyczalnia i Czytelnia Główna: poniedziałek – piątek od 9.00 do 19.00